Carrier 38QHF060 Installation guide

Carrier
Brand
Carrier
Model
38QHF060
Category
Split-system air conditioners
Type
Installation guide

This manual is also suitable for

900x315x860
590333
Right rear side
refrigerant pipe
hole 65φ
Left rear side
refrigerant
pipe hole 65φ
Indoor unit outline
45
42QHF025 :(A:800, B:275, C:100, D:95)
A
CD
B
Right rear side
refrigerant pipe
hole 65φ
Left rear side
refrigerant
pipe hole 65φ
Indoor unit outline
45
A
CD
B
42QHF036 / 42QHF050: (A:940, B:275, C:110, D:100)
Right rear side
refrigerant pipe
hole 65φ
Left rear side
refrigerant
pipe hole 65φ
Installation plate
A
21.5
CD
B
45
42QHF060 / 42QHF065 : (A:1045, B:315, C:293, D:163)
Air freshening filter(1)
(used to install on Air filter)
6
Right rear side
refrigerant pipe
hole 65φ
Left rear side
refrigerant
pipe hole 65φ
Indoor unit
outline
C389
A
B
52
52
332 D
Indoor unit outline
42QHF080: (A:1259, B:362, C:172, D:257)
810x310x558
U
20cm or more
700x240x540
Model
38QHF025
38QHF036 / 38QHF050
845x320x700
38QHF060
38QHF065 / 38QHF080
The holes for fixing anchors should be 5mm.
Power supply from outdoor
Power
supply
W 1 2(N) S W 1 2(N) S L N
Do not put drain
end into water
Connection diagrams
Use a vacuum pump to evacuate air from the
system until 76cmHg, do the reakage check before
remove the charge hose.
Fully open the packed valve stem before test
operation, use some leak detector or some soap
water to check the refrigerant line connections.
Wire cross section is depending on the rated (max) current which is indicated as below:
Rated (max) current of appliance (A)
11.5QHF025 / QHF036
12.5QHF050
14.5QHF060 / QHF065
16.0QHF080
For all QHF family
1.Lift the indoor unit front panel.
2.Remove the indoor unit electrical cover and cord clamp by loosening the screws.
3.Pass the connecting wires from the back of indoor unit and connect to the indoor terminal block.
1. Remove the electrical cover and cord clamp by loosening the screws.
2. Connect wires to the outdoor terminal block by same sequence to indoor unit.
Press the ON/OFF button on remote control
to begin testing.
Press MODE button, select COOL, HEAT, FAN
mode to check if all functions work correctly.
Press the manual button once to energize
the unit.
When ambient temperature is lower than 17 ,
the unit can not be controlled by remote
control to run in cooling mode. For this
condition, manual operation must be used.
Open front panel of the indoor unit;
Model
  • Page 1 1
  • Page 2 2

Carrier 38QHF060 Installation guide

Carrier
Brand
Carrier
Model
38QHF060
Category
Split-system air conditioners
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents