Assemble FRONT LEG to SEAT as illustration shown.
Assembly step
STEP 1
STEP 2
Assemble BACKREST to SEAT as illustration shown.
Page 2 of 2
3
2 -80mm
3
2 -80mm
STEP 1b
3
1 -40mm
STEP 1a
A
B
C
DO NOT TIGHTEN THE SCREWS UNTIL
FULLY SET UP.
DO NOT TIGHTEN THE SCREWS UNTIL
FULLY SET UP.
Assemble STRETCHER to LEG as illustration shown.(NOTE : USE HARDWARE IN BOX 4)
STEP 3
STEP 3a
4 -38mm
TIGHTEN ALL THE SCREWS !!!
D
E
NOTE:
To ensure that chair is level, assemble the chair on flat & soft surface. DO NOT tighten all the screw
& bolts until the chair been adjust & level all the legs so that they do not wobble. Once adjusted then
only tighten all the screw using Allen Key while making sure that the unit remain level.
STEP 2a
STEP 2b
4 -38mm
R
5
5