Vango Sigma 300 Pitching Instructions

Brand: Vango

Model: Sigma 300

Type: Pitching Instructions

Vango Sigma 300:

The Vango Sigma 300 is a three-person tent with a flysheet-first pitching system. This makes it quick and easy to set up, even in bad weather. The tent is also wind-resistant and has a waterproof rating of 4,000mm, making it suitable for all but the most extreme conditions.

The Sigma 300 has a spacious interior with plenty of room for three people and their gear. The tent also features a large porch area, which is perfect for storing wet or dirty gear, or for cooking and eating.

Vango Sigma 300:

IF YOU HAVE ANY PROBLEMS PLEASE CONTACT YOUR LOCAL RETAILER or

AMG Group Ltd., Kelburn Business Park, Port Glasgow, Scotland. PA14 6TD.

UK Consumer Hotline: 0844 811 0535 E-Mail: [email protected]

Calls to our Customer Hotline cost 5p per minute.

Calls from mobile phones, cable networks or public payphones will generally cost more.

Flysheet First Pitching

1. Assemble poles and lay them parallel on the ground (3

poles - 2 longer poles and 1 shorter pole).

2. The poles are colour coded to match corresponding

pole sleeve entry points.

3. Open out flysheet and position in required direction.

Insert the two longer poles diagonally through pole

sleeves on outside of flysheet.

4. Insert the shorter porch pole into front pole sleeve

over doorway.

5. Locate one end of each diagonal pole onto pin system

at flysheet corners (see figure 1).

6. Push each diagonal pole into an arch from opposite

end and locate pole ends onto corresponding pin

system.

7. Locate one end of the porch pole onto corresponding

pin system.

8. Push porch pole into an arch from opposite side and

locate pole end onto pin system.

9. Peg down all rings of ring and pin system using pin-

pegs. (see figure 2)

10. Pull out porch doorway and peg down elastic pegging

points at the base using pin-pegs.

11. Peg out all remaining shock-cord pegging points on

the base of the flysheet using pin-pegs.

12. Peg out ALL guy lines using pin-pegs ensuring that guy

line fabric attachment points are evenly tensioned.

Inner

1. Open out inner inside flysheet and position doorway to

correspond with flysheet entrance.

2. Starting from the rear corners of the tent, attach the

hooks on the groundsheet to corresponding ring on

base of the flysheet.

3. Suspend inner to flysheet by means of elasticated

toggles on inner tent to corresponding rings on inside

of flysheet.

4. Attach hooks on porch groundsheet to corresponding

rings on base of flysheet

The inner tent and flysheet can remain attached when

pitching or packing. However, in humid or very wet

weather, the underside of the flysheet may be coated with

condensation. If this occurs, it may be advisable to detach

the inner and pack it separately to avoid the inner tent

becoming wet.

Tent Pitching Instructions

Sigma 300

Figure 1

Figure 2

Vango Sigma 300 Pitching Instructions

Brand: Vango

Model: Sigma 300

Type: Pitching Instructions

Vango Sigma 300:

Download PDF

report

Vango Sigma 300 Pitching Instructions

Vango Sigma 300 Pitching Instructions

Related papers

Other documents