4
E F
G H
V1
V2
1000
770
800
145
85
175
95
Nozzles
ENGLISH
Water canon
MA55-21 GB Translation of the original instructions (Swedish)
Product description
The water canon is available with several nozzles for dierent water jets.
It must be connected with its own pump and two separate inlets. The pump must be placed under the water level of the pool.
Two separate inlets shall be mounted in the pool with a safety distance of 2 meters between them.
The water canon can be turned on/o with a pneumatic or electric button (not included).
Technical data
Measure Height 1000 mm
Depth 770 mm
Flow recommendation Up to 11 m3/h
Connection 1½” inner thread
Safety
Note! The outlet of the water canon should not extend over the edge of the pool if the pool is shallow.
Inattentive swimmers can hit their heads.
Installation
1. Prepare for a concrete foundation in the appropriate place at the side of the pool.
2. Connect the pipe (PVC Ø63) for water on the support.
3. Pour the concrete to x the support. Be sure that the mounting plate on the support
is in level and at the desired height.
4. Mount the water canon on the support with the cap nuts enclosed.
5. Mount the nozzle and make sure it is fastened properly.
6. Connect PVC pipe Ø63 with valves on to pump and inlets. The pump shall be
placed under the water level of the pool.
7. Open the valves.
8. When the pump is lled with water, start the pump.
9. Adjust the water ow with valve V1 to the desired level.
Recommended water values
Chlorine: max 3 mg/liter (ppm)
Chloride (salt) content: max 250 mg/liter
pH-value: 7.2–7.6
Alkalinity: 60 –120 mg/liter (ppm)
Calcium hardness: 100 – 300 mg/liter (ppm)