Otter Outdoors Rear ATV Monster Box Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the Otter Outdoors ATV Monster Boxes, both the medium and large sizes. This document details how to mount these boxes to your ATV using u-bolts, straps, and basic tools like a drill and wrench. I understand the process of drilling holes, positioning the box, and securely fastening everything. I'm ready to help with any questions you have about these instructions.
  • What tools are required for the installation?
    What is the proper spacing for the drilled holes?
    What items are included in the parts list?
411 West Congress St., Maple Lake, MN 55358 Toll Free 877-466-8837 www.otteroutdoors.com
ASSEMBLY INSTRUCTIONS FOR MEDIUM AND LARGE ATV MONSTER BOXES
Parts List: Tools Required:
Square U-Bolts (4) Drill with 5/16” bit
Flat Strap (4) Marker to layout holes
¼” Nylock Nuts (8) 7/16” Wrench
Installation:
1. Set and square Monster Box (item 5) on rack (item 4) of ATV.
2. Layout holes (one on each side of bar) to be drilled in bottom of box, according to rack.
Configuration. (Best to use outside edge bars for ease of assembly).
3. Hole centers should be 1 ½” apart to fit u-bolts provided.
4. Drill 5/16 holes through the box
5. Slide U-Bolts (item 1) through box and around bar.
6. Slide Flat Strap (item 2) up on U-Bolt
7. Tighten ¼” Nylock Nuts (item 3) down to Flat Strap.
LARGE MONSTER BOX: MEDIUM MONSTER BOX:
Instructions - 70753
/