Flex Fit™ Pairing Guide
191-60000-M002 R0
0
January 2021
N49 W13650 Campbell Drive
Menomonee Falls, WI 53051
Phone 262.783.3500
Toll-Free Phone 800.288.8178
Canada
Toll Free Phone: 800.792.7253
Fax: 905.8281526
For service or technical
information contact:
1.866.MAG.SERV
(1.866.624.7378)
Outside the U.S. & Canada
call 1.262.783.3500, press 3
www.columbusmckinnon.com/magnetek
© Copyright 2021 Magnetek
A.
Transmitter-to-Transmitter Pairing
Enter Pairing mode on BOTH transmitters by following these steps:
1)
Press down the STOP button (transmitter power off).
2)
Press and hold PB1 and PB3 at the same time.
3)
Reset the STOP button by rotating it clockwise or counterclockwise; it will pop up (transmitter power
on) and briefly afterwards release PB1 & PB3.
4)
Now both transmitters are in Remote Pairing mode, at the same time press and hold PB2 on the
original transmitter (Status LED off and LED-B constant red) and PB1 on the new transmitter
(Status LED blinks green and LED-A constant red).
5)
When the Status LED (receiving data end) turns to constant green while both pushbuttons are still
pressed down, the pairing is complete.
6)
Exit Remote Pairing mode by pressing down the STOP button on both transmitters.
NOTE: During remote pairing ensure the distance between the two transmitters is within 1 meter.
Flex Fit™ Pairing Guide
191-60000-M002 R0
0
January 2021
N49 W13650 Campbell Drive
Menomonee Falls, WI 53051
Phone 262.783.3500
Toll-Free Phone 800.288.8178
Canada
Toll Free Phone: 800.792.7253
Fax: 905.8281526
For service or technical
information contact:
1.866.MAG.SERV
(1.866.624.7378)
Outside the U.S. & Canada
call 1.262.783.3500, press 3
www.columbusmckinnon.com/magnetek
© Copyright 2021 Magnetek
B.
Receiver-to-Transmitter Pairing
Enter Pairing mode by following these steps:
1)
Ensure power is applied to the receiver.
2)
Press down the STOP button (transmitter power off).
3)
Press and hold PB1 and PB3 at the same time.
4)
Reset the STOP button by rotating it clockwise or counterclockwise; it will pop up (transmitter power
on).
5)
Now the new transmitter is in Remote Pairing mode, press and hold both the PAIRING button
located on the receiver cover and PB3 on the transmitter at the same time. When the transmitter
Status LED turns to constant green while both pushbuttons are still pressed down the pairing is
complete.
6)
Exit Remote Pairing mode by pressing down the STOP button (transmitter power off).
NOTE: Make sure the pairing process is executed within distance of 10 meters from one another and no
other active receivers nearby. During the pairing process the receiver MAIN relays must be deactivated
(relay open)
/
