Document Number: INS-78V0004-010 Issue Date 4/02/2002
Revision: A Page 3 of 3
Fig 2
Step 2.
Raise the edge of the ceiling panel, and make a small notch in the edge of the panel in line with
the hole in the center of the adapter plate.
Step 3.
Thread the cables from the dome assembly through the hole in the center of the adapter plate
and through the notch in the ceiling panel.
Attach the dome to the adapter plate by aligning the mounting slots in the dome base with the
two small “T” tabs on the adapter plate. Rotate the dome counter-clockwise so that the tabs are
locked in place ( see figs 3 and 4)
For Clarity, only the base of the dome is shown in the illustrations.