PD-MX30

Shimano PD-MX30 Service Instructions

  • Hello! I am an AI chatbot trained to assist you with the Shimano PD-MX30 Service Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What is the recommended tightening torque for mounting the pedals on the crank arms?
    What is the correct type of wrench to use for mounting the pedals?
    How do I identify the right and left pedals?
    What is the recommended tightening torque for the pins?
    What should I do if the pins become worn or damaged?
    How can I resolve any trouble with the rotating parts of the pedal?
    Is there an optional reflector set available for the pedals?
L
15
1.5 mm Allen key
Pin
L
If the pins become worn or damaged, replace them with new pins.
Pin maintenance
15 mm spanner
Use a 15 mm spanner to mount the pedals on the crank arms. The
right pedal has a right-hand thread; the left pedal has a left-hand
thread.
Pay attention to
the mark
R: right pedal
L : left pedal
Tightening torque:
35 – 55 N·m {304 – 477 in. lbs.}
Mounting the pedals on the crank
arms
A 6 mm Allen key cannot provide a sufficient tightening torque.
Always be sure to use a 15 mm spanner.
Note:
Tightening torque:
0.5 – 0.8 N·m
{4.3 – 6.9 in. lbs.}
Technical Service Instructions
SI-MX30B-001
Pedals
PD-MX30
Dec. 2008 by Shimano Inc. PIT. SZK. Printed in Malaysia
C
General Safety Information
Be sure to attach reflectors to the bicycle when riding at
night. Do not continue riding the bicycle if the reflectors
are dirty or damaged, otherwise it becomes more difficult
for oncoming vehicles to see you.
Obtain and read the service instructions carefully
prior to installing the parts. Loose, worn, or damaged
parts may cause serious injury to the rider.
We strongly recommend only using genuine Shimano
replacement parts.
If you have any questions concerning your pedals,
contact a professional dealer.
Read these Technical Service Instructions carefully, and
keep them in a safe place for later reference.
WARNING
NOTE:
Before riding the bicycle, check that there is no play or
looseness in the connection. Also, be sure to retighten
the crank arms and pedals at periodic intervals.
In addition, if pedaling performance does not feel normal,
check this once more.
Parts are not guaranteed against natural wear or
deterioration resulting from normal use.
For maximum performance we highly recommend
Shimano lubricants and maintenance products.
– To avoid serious injuries:
Please note: Specifications are subject to change for improvement without notice. (English)
One Holland, Irvine, California 92618, U.S.A. Phone: +1-949-951-5003
Industrieweg 24, 8071 CT Nunspeet, The Netherlands Phone: +31-341-272222
3-77 Oimatsu-cho, Sakai-ku, Sakai, Osaka 590-8577, Japan
An optional reflector set is available. Please contact a professional
dealer for details.
Mounting the reflectors (optional)
If you experience any trouble with the rotating parts of the pedal,
the pedal may require adjustment. Obtain advice from a
professional dealer.
Maintenance of the axle units
/