Thomann GmbH · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de
DocID: 378753_19.04.16
Studio Desk WS100
ö
#
$
1/2
Assembly instructions
For mounting the studio desk, use the
supplied screws and washers. Use a soft
padding to avoid damage to the compo-
nents.
1. Pre-assemble both side modules of the
desk:
Each of them consists of two side pa-
nels with recessed rack rails and three
connection struts. Screw the struts
with each four metal screws.
2. Screw the connection strut with four
metal screws between the two side
modules.
3. Attach the brackets for the lower
shelves to the lower struts of the side
modules.
%
&
'
Thomann GmbH · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de
DocID: 378753_19.04.16
2/2
Studio Desk WS100
For the transport and protective packaging,
environmentally friendly materials have been
chosen that can be supplied to normal
recycling. Ensure that plastic bags, packaging,
etc. are properly disposed of. Do not just
dispose of these materials with your normal
household waste, but make sure that they are
fed to a recovery. Please follow the notes and
markings on the packaging.
Ensure that plastic bags, packaging, etc. are disposed of
properly and are not within reach of babies and young
children. Choking hazard!
Because of its heaviness, at least two people are always requi-
red for the transport and installation of the studio desk.
Technical specications
Materials used:
– steel sheet (side panels, struts)
– wood (table top)
Dimensions (W×H×D):
1950×910×850mm
Weight: 40kg
4. Screw the shelves to the lower struts of
the side modules.
5. Screw the rear small table top on the
connection strut between the two side
modules.
6. Screw the table top on the support
arms of the side modules.
/