Antenna Discharge Unit
(NEC Section 810-21)
ä
ä
Ground Clamps
Grounding Conductors
(NEC Section 810-21)
Power Service Grounding
Electrode System
(NEC Art. 250, Part N)
Ground Clamp
Electrical
Service
Equipment
(4) 1/4-20 Flanged
Hex Nuts
(2) Mast Clamps
Fits pipe/towers of 1"
to 2" in diameter.
HOW TO PROVIDE LIGHTING
PROTECTION
FOR TV ANTENNA AND SET
STEP 1. Mount the lightning arres-
tor as close as possible to where the
downlead enters the house.
STEP 2. The ground wires for both
the mast and the downlead should
be copper or aluminum wire, number
eight (8) or larger.
STEP 3. The downlead wire from
the antenna to the lightning arrestor
should be secured every four (4) to
six (6) feet to prevent whipping.
NOTE: In the case of a "ground up"
antenna installation, it may not be
necessary to ground the mast if the
mast extends four or more feet into
the ground. Consult a TV service-
man for proper depth in your location.
Adjust mount pipe
for correct angle.
Winegard Company
3000 Kirkwood St., Burlington, IA 52601-2000
Printed in U.S.A. © Winegard Company 1997 2451723 Rev. 11/01
WINEGARD
Pipe/Tower Mounting Kit
Models DS-2000/2002
Antenna
Lead-in Wire
WARNING
INSTALLATION OF ANTENNAS NEAR POWER LINES IS DANGEROUS.
FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
INSTRUCTIONS
STEP 1. Assemble kit as
shown.
STEP 2. Tighten U-bolts,
do not overtighten and
bend pipe/tower.
STEP 3. Adjust mount pipe
for correct angle.
STEP 4. Tighten bolts
holding pipe. Do not over-
tighten and bend pipe.
®
90 DAY LIMITED WARRANTY
Winegard Company warrants this Winegard product against any defects in materials or
workmanship within 90 (ninety) days from date of purchase. No warranty claim will be honored unless
at the time the claim is made, you present proof of purchase to an authorized Winegard dealer (if
unknown, please contact Winegard Company, 3000 Kirkwood Street, Burlington, IA 52601-2000,
Telephone 800-288-8094).
Winegard Company (at its option) will either repair or replace the defective product at no charge
to you. This warranty covers parts, but does not cover any costs incurred in removal, shipping
or reinstallation of the product. This limited warranty does not apply if the product is damaged,
deteriorates, malfunctions or fails from: misuse, improper installation, abuse, neglect, accident,
tampering, modication of the product as originally manufactured by Winegard, usage not in
accordance with product instructions or acts of nature such as damage caused by wind, lightning,
ice or corrosive environments such as salt spray and acid rain.
The 90 Day Warranty is provided on the condition that the equipment is properly delivered with all
handling and freight charges prepaid to your Winegard dealer for return to our factory for repair or
replacement. Winegard dealers will arrange for the replacement or repair and return to you without
charge the product which failed due to defective material or workmanship.
WINEGARD COMPANY WILL NOT ASSUME ANY LIABILITIES FOR ANY OTHER WARRANTIES,
EXPRESS OR IMPLIED, MADE BY ANY OTHER PERSON.
ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING
WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY ARE
LIMITED TO THE 90-DAY PERIOD OF THIS WARRANTY.
The foregoing shall be the sole and exclusive remedy of any person, whether in contract, tort or
otherwise, and Winegard shall not be liable for incidental or consequential damage or commercial
loss, or from any other loss or damage except as set forth above.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion of
limitation of incidental or consequential damages, so the above limitations or exclusions may not
apply to you.
This warranty gives you specic legal rights and you may also have other rights which vary from
state to state.
Rev. 2/08
* NOTICE: If you require a longer
U-bolt (4.00") order part # 1160322.
(2) U-Bolts
*
1
Winegard YA-7000 User manual
Winegard GS-2200 User manual