All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
COMBINATION INSTALLATIONS
DCT Series Drop-In Gas Cooktop
with ERVxx15 Raised Vent
Document # PGCI-023
Revised 10/28/11 Page 1/1
4 1/4” (10.8 cm) min.
from mounting surface to
combustibles below
cooktop chassis
E
F
C
D
Minimum distance to combustible side
wall above countertop (both sides)
F
Vertical
combustible
surface
Rear
wall
1 5/8” min.
(4.1 cm)
Installation Type (C) Minimum (D) (E) (F) Minimum
DCT305 with ERV3015 raised vent
3/8” (1.0 cm) 22 3/4" (57.8 cm)
27 5/8” (70.2 cm)
6 7/8" (17.5 cm)
DCT365 with ERV3615 raised vent 33 5/8" (85.4 cm)
Stiffener
Cabinet face
Countertop
Floor
3/8” min. (1.0 cm) space
behind raised vent
chassis to clear stiffener
3/8” min. (1.0 cm)
flat countertop overhang
required behind cutout
ERVxx15 raised vent.
Check raised vent
dimensions/specifications
to determine proper fit
DCT Series cooktop
Cutout tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated
Cutout Dimensions
SIDE VIEW - DCT SERIES COOKTOP WITH APPROVED RAISED VENT
Raised Vent Compatibility
If installing the cooktop with a raised vent, install only
the Dacor raised vent model specified in the table
below. Installation of any other raised vent model may
cause improper operation.
WARNING
• Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
• All appliances must be installed in accordance with the
accompanying installation instructions.
