Asus S370 User manual

Type
User manual

This manual is also suitable for

Asus S370 is a CPU card designed to allow Slot 1 motherboards to accept socket 370 processors with Front Side Bus running at up to 133MHz. It supports both Coppermine and Celeron processors, providing an inexpensive way to upgrade Pentium II/III computers using lower-cost socket 370 processors. The card can acquire temperature data from the processor's thermal diode and send it to the motherboard that supports CPU thermal monitoring.

Asus S370 is a CPU card designed to allow Slot 1 motherboards to accept socket 370 processors with Front Side Bus running at up to 133MHz. It supports both Coppermine and Celeron processors, providing an inexpensive way to upgrade Pentium II/III computers using lower-cost socket 370 processors. The card can acquire temperature data from the processor's thermal diode and send it to the motherboard that supports CPU thermal monitoring.

E506
S370 Series
CPU Cards
Installation Guide
®
2
ASUS S370 Series
Installation Guide
Introduction
The ASUS S370 Series CPU cards allow Slot 1 motherboards to accept socket
370 processors with Front Side Bus running at up to 133MHz. The ASUS
S370 Series CPU cards support both Coppermine and Celeron processors to
give Slot 1 motherboard owners an inexpensive way to upgrade their Pentium
II/III computers using lower costing socket 370 processors. Since socket 370
processors are designed on the Pentium II/III design, the only difference is
the package form factor. Additionally, the S370 Series CPU cards can ac-
quire temperature data from the processors thermal diode and send it to the
motherboard that supports CPU thermal monitoring.
The following are pictures of the ASUS S370 Series CPU cards with black
plastic retainers attached to the edges. The retainers are used to hold the
ASUS S370 Series CPU cards in place using the motherboard’s Slot 1 re-
tention mechanisms.
ASUS S370 Series
Installation Guide 3
S370-133 CPU Card
ASUS S370-133 CPU Card (standard model)
• 133MHz FSB Coppermine/Celeron Processor Support
• Better Support with Full Retainer
Fin
Slot 1 Compatible Connector
Retainer
Socket 370
CPU Voltage Jumpers
4
ASUS S370 Series
Installation Guide
S370-L CPU Card
ASUS S370-L CPU Card (for smaller cases)
133MHz FSB Coppermine/Celeron Processor Support
Low Profile
Fin
Slot 1 Compatible Connector
Retainer
Socket 370
CPU Voltage Jumpers
ASUS S370 Series
Installation Guide 5
Windows 98
Using the S370 Series CPU Cards
The general procedure for using the ASUS S370 Series CPU cards:
1. Check the voltage setting for your socket 370 processor using the jump-
ers on the card if necessary. For current socket 370 processors, the de-
fault setting should be used.
2. Install the socket 370 processor. Installation of socket 370 processors is
exactly like socket 7 processors. Lift the brown lever to 90° to install the
processor and lower the brown lever to lock the processor.
3. Install the CPU fan.
4. Insert the ASUS S370 Series CPU cards into Slot 1 on the motherboard.
The two fins on the sides of the ASUS S370 Series CPU cards must
catch on the retention mechanism so that it locks in place.
5. Connect the socket 370 processors fan connector to the motherboard.
6. Make sure that no wires or objects come in contact with the fan and youre
done!
6
ASUS S370 Series
Installation Guide
Setting up the S370 Series CPU Cards
Setting the CPU voltage is not necessary for current socket 370 processors.
If required, your socket 370 processor should have its voltage requirement
printed on its surface or documentation. If no voltage is indicated or you are
not sure, use the CPU Def. setting as shown below. Notice that JP6 should
be set for the S370-133 CPU card to distinguish between Coppermine and
Celeron processors. The S370-L CPU card can automatically distinguish
these two types of CPU.
WARNING! Exceeding your socket 370 processors required voltage
can damage your processor permanently! Make sure that the jumpers are
as shown for CPU Def. unless otherwise specified before powering on
your motherboard.
ASUS S370 Series
Installation Guide 7
Setting up the S370 Series CPU Cards
Socket 370 CPU Voltage
1.50Volts
123
1.55Volts
123
1.60Volts
123
1.65Volts
123
1.75Volts
123
1.70Volts
123
1.80Volts
123
2.00Volts
123
2.05Volts
123
2.10Volts
123
2.20Volts
123
2.40Volts
123
2.30Volts
123
2.50Volts
123
JP1
JP2
JP3
JP4
JP5
JP1
JP2
JP3
JP4
JP5
1.90Volts
123
1.85Volts
123
1.95Volts
123
CPU Def.
(Default)
123
2.60Volts
123
JP6
123 123
Using Coppermine Processor
(Default)
JP6
Using Celeron Processor
For S370-133 CPU Card
P/N 15-xxxxxxxxx
®
S370 Series
CPU Cards
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Asus S370 User manual

Type
User manual
This manual is also suitable for

Asus S370 is a CPU card designed to allow Slot 1 motherboards to accept socket 370 processors with Front Side Bus running at up to 133MHz. It supports both Coppermine and Celeron processors, providing an inexpensive way to upgrade Pentium II/III computers using lower-cost socket 370 processors. The card can acquire temperature data from the processor's thermal diode and send it to the motherboard that supports CPU thermal monitoring.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI