FLEXCO Chisel Operating instructions

Flexco® Cracking Chisel

• Replacementofprematurelywornplatesinminuteswithout

replacingentiresplice.

• Requiresonlyahammer.

• reesizesavailable.

 C1CforNo.1,140or190nuts

 C2CforNo.1-1/2,2or2-1/4nuts.

 C3CforNo.2-1/2and3nuts

WiththeFlexco®CrackingChisel,excessivelyworntopplatesand

individualfastenerscanbereplacedquicklyandeasily.Onlya

hammerandaFlexco®CrackingChiselarerequired.Removalof

prematurelywornplatesavoidsinstallingacompletenewsplice.

Savestimeandmoney.Twosimplesteps.

X0488

2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 U.S.A.

Tel: 1-630-971-0150 • Fax: 1-630-971-1180 • E-mail: info@exco.com

Visit www.ﬂexco.com for other Flexco locations and products.

1. PlaceCrackingChiseloverthenutandhitwitharm

blow.Usea2lb.orheavierhammer.Besuretowear

safetygoggles.NOTE: Positionwornplateoversolid

backingbeforestrikingchisel.



2. Aernutsareremoved,replaceplates,bolts,andnuts.

Tightennutsandbreakoffexcessiveboltends.NOTE:

Tightennutssoplatescompressintobeltcoverand

puckerbeltaroundplateedge.