2. Radiant
  3. WNREZK10WH

Radiant WNREZK10WH, WNREZK15WH, WNREZK50WH Installation guide

  • Hello! I've read the Legrand installation instructions for the Smart Switch models WNREZK10WH, WNREZK50WH, and WNREZK15WH. This document explains how to expand your Easy Kit with additional wired or wireless devices, how to pair the new devices, and the differences between wired and wireless device behavior. I'm ready to answer your questions about the installation process or the features of these Legrand devices.
  • How many devices can I add to my Easy Kit?
    What is the maximum distance allowed from a wired device?
    How do I pair a wireless device?
    What's the purpose of EZ setup button?
Expand your Easy Kit:
You can easily add additional wired or wireless smart with Netatmo
switches, dimmers, and outlets to your pre-paired Easy Kit without the
need for the gateway.
NOTES:
- Add any combination of up wired/wireless devices up to 20.
- Devices must be 30ft. or less from nearest wired device.
Step 1: Prepare New Devices
Wired devices: Wire and power all hardwired
devices you wish to add to your pre-paired Easy Kit
per installation instructions in box. LEDs on wired
devices you wish to add will be solid red when
powered.
Wireless devices: Install on flat surface or over wall
box per installation instructions in box. DO NOT
remove battery tabs yet.
Step 4: Adding Hardwired Devices.
(if no hardwired devices, skip to step 5)
Press & release the EZ setup button on device you
are going to add. LED on device will briefly flash
green, then turn solid orange.
Note: All wired switches, dimmers, outlets, and
plug-ins added will ONLY control the individual
load wired to or plugged into it.
Step 2: Open Network
Press & release the EZ setup button on the wired
device that came with your pre-paired Easy Kit. LED
will turn solid orange.
Note: You will need to remove the wall plate &
subplate to access the EZ setup button.
Step 5: Close Network
Press & release twice the ON and OFF paddles on
the wireless switch simultaneously, pressing and
releasing 2 times consecutively. LEDs on all
devices will go off.
Step 3: Adding Wireless Devices
(skip to step 4 to add hardwired devices)
Pull battery tab from wireless device you are going
to add. Press & release the wireless device’s ON or
OFF paddle once to pair it. LED on device will briefly
flash green, then turn orange, then go off.
Note: All wireless switches or dimmers added will act
as group controllers, controlling ALL lights connected
to any of the wired smart switch/dimmer/outlet.
Step 6: Test Your Device
For wireless switches, push on paddle to ensure
load(s) is turning on.
For outlets/plug-ins, plug lamp into outlet marked
controlled. Using wireless switch connected to
outlet, press on paddle to control lamp on/off.
INSTALLATION INSTRUCTIONS:
EXPANDING AN EASY KIT WITH ADDITIONAL SMART WITH NETATMO DEVICES
No. 341389 06/23
Catalog Number(s): WNREZK10WH, WNREZK50WH, WNREZK15WH
/