Expand your Easy Kit:
You can easily add additional wired or wireless smart with Netatmo
switches, dimmers, and outlets to your pre-paired Easy Kit without the
need for the gateway.
NOTES:
- Add any combination of up wired/wireless devices up to 20.
- Devices must be 30ft. or less from nearest wired device.
Step 1: Prepare New Devices
Wired devices: Wire and power all hardwired
devices you wish to add to your pre-paired Easy Kit
per installation instructions in box. LEDs on wired
devices you wish to add will be solid red when
powered.
Wireless devices: Install on flat surface or over wall
box per installation instructions in box. DO NOT
remove battery tabs yet.
Step 4: Adding Hardwired Devices.
(if no hardwired devices, skip to step 5)
Press & release the EZ setup button on device you
are going to add. LED on device will briefly flash
green, then turn solid orange.
Note: All wired switches, dimmers, outlets, and
plug-ins added will ONLY control the individual
load wired to or plugged into it.
Step 2: Open Network
Press & release the EZ setup button on the wired
device that came with your pre-paired Easy Kit. LED
will turn solid orange.
Note: You will need to remove the wall plate &
subplate to access the EZ setup button.
Step 5: Close Network
Press & release twice the ON and OFF paddles on
the wireless switch simultaneously, pressing and
releasing 2 times consecutively. LEDs on all
devices will go off.
Step 3: Adding Wireless Devices
(skip to step 4 to add hardwired devices)
Pull battery tab from wireless device you are going
to add. Press & release the wireless device’s ON or
OFF paddle once to pair it. LED on device will briefly
flash green, then turn orange, then go off.
Note: All wireless switches or dimmers added will act
as group controllers, controlling ALL lights connected
to any of the wired smart switch/dimmer/outlet.
Step 6: Test Your Device
For wireless switches, push on paddle to ensure
load(s) is turning on.
For outlets/plug-ins, plug lamp into outlet marked
controlled. Using wireless switch connected to
outlet, press on paddle to control lamp on/off.
INSTALLATION INSTRUCTIONS:
EXPANDING AN EASY KIT WITH ADDITIONAL SMART WITH NETATMO DEVICES
No. 341389 06/23
Catalog Number(s): WNREZK10WH, WNREZK50WH, WNREZK15WH
-
1
Radiant WNREZK50WH Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Legrand adorne ARTR153W4 Specification
-
Legrand Adorne Collection Switches/Dimmers/Outlets User manual
-
Legrand ADTP703TUM4 User manual
-
Legrand adorne APTR15TM4 Specification
-
Bticino RA00185AC-11-PC Smart Installation guide
-
IKEA TRÅDFRI Smart Lighting User manual
-
INSTEON 2476D User manual
-
Westcott Flex Cine DMX RGBW Mat 1-Light Set (1' x 1') User manual
-
-
Hager coviva Smartbox TKP100A Configuration manual