SIDE FRAME
QTY: 2
BUTTON HEAD BOLT
LEG
SIDE
ASSEMBLY
BUTTON HEAD BOLT
CASTERS
HANG BARS
HAND WHEEL
PS4-ADJ ASSEMBLY INSTRUCTIONS
1
SLIDE ONE OF THE LEGS THROUGH THE LOWER FITTING ON THE SIDE FRAME. ALIGN THE HOLE IN THE FITTING WITH
THE HOLE IN THE LEG AND SECURE IT LOOSELY WITH A BOLT. REPEAT FOR THE OTHER LEG AND SIDE FRAME.
NOTE:
THE 90 DEGREE FITTING ON THE LEGS SHOULD BE POINTING DOWN.
1
2
2
3
4
4
3
SECURE THE OTHER SIDE ASSEMBLY FROM STEP 1 WITH THE REMAINING BOLTS AS SHOWN.
NOTE
: THE BOLTS FROM ALL PREVIOUS STEPS SHOULD BE TIGHTENED NOW.
LOOSEN ALL (4) HAND WHEELS TO INSTALL THE HANG BARS AS SHOWN. TIGHTEN THE HANDWHEELS TO CLAMP THE
HANG BARS AT THE DESIRED HEIGHTS.
THREAD THE CASTERS INTO THE 90 DEGREE FITTINGS ON THE LEGS.
5
5
LOOSELY SECURE THE CROSS SUPPORT AS SHOWN WITH (1) BOLT.
PAGE 1
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI