Page is loading ...
F-12-753
May, 1995
2-1/2"
2-1/2"
10-3/4"
SIEVE ASSY. - 948148
12-3/4"
16-1/2"
(4) SCREW - No. 10—24 x 1-in. Lg.
(4) WASHER - No. 10
(4) LOCKWASHER - No. 10
SUPPORT BRACKET - 948149
HOLE PATTERN:
3/8-in. on 1-in. Center
GATE ASSY. - 948150
(See Detail)
HOSE - 20W23 (2-ft.)
HOSE CLAMP - 994471
TUBE GUIDE
CLAMP - 999626
(Accy.)
*WING NUT
14W87
*PIN - 62350025
*SHAFT - 948151
SCREW - No. 6—32 x 3/8-in. Lg.
(2) DISK - 14W26
DISK - 14W27
EH-10 & -11 Adaptor Bracket - 2075665
Includes:
Bracket - 948152
(4) Screw—3/8 - 16 x 1-1/4-in. Lg.
(4) Lockwasher - 3/8
Tube Guide Clamp - 999626
*GATE SHAFT ASSY - 948153
Includes:
WING NUT - 14W87
SHAFT - 948151
PIN - 62350025
FLUX HOPPER ASSEMBLY
Part No. 948147
The Flux Hopper Assembly (P/N 948147) provides a convenient means of storing 25 lbs. of submerged arc flux and
transmitting it to the welding zone. The hopper is supplied complete with a butterfly outlet valve, discharge hose and
a support bracket designed for mounting the hopper on a flat vertical surface. The hole pattern (in the support
bracket) consists of two 3/8-in. holes, one of which is slotted to provide 45° of mounting flexibility from the vertical.
The square hopper bottom allows the hopper to be repositioned on the gate assembly for additional mounting flexibil-
ity.
CAUTION: Before moving the Flux Hopper/Welding Head Assemblies, make sure the hopper sieve is secured by the
safety chain.
To mount the hopper below an EH-10 or -11 welding head, an optional Adaptor Bracket, P/N 2075665, is required.
Also available as an optional accessory is a Tube Guide Clamp (P/N 08V77) designed to secure the flux hose to the
busbar and nozzle assembly.
REPLACEMENT PARTS
INSTRUCTIONS for
9"
PARTS SUPPLIED
Qty. Description
2 Screw 3/8—16 x 1-1/2-in. Lg.
2 Washer 3/8
2 Lockwasher 3/8
2 Hex nut 3/8—16
F-12-753 5/95 1M Printed in U.S.A.
Be sure this information reaches the operator.
You can get extra copies through your supplier.
/
