Anker PowerCore AC User manual

Type
User manual
1 2 3 4
Welcome Guide
PowerCore AC
|
使用说明书 | 使用說明書
What’s Included
| 包装清单 | 包裝內容物
At a Glance
| 概观 | 概覽
2
1
3
5 4 6
Power button
| 电源键 | 電源按鈕
USB output port
USB | USB输出端口 | USB輸出端口
DC input port
DC | DC输入端口 | DC輸入端口
AC output switch
AC | AC 输出开关 | AC輸出開關
AC output port
AC | AC 输出端口 | AC輸出端口
LED indicators
LED | LED指示灯 | LED指示燈
Using Your PowerCore
PowerCore | 使用您的PowerCore | 使用您的PowerCore
Check the power level
| 查看剩余电量 | 檢查剩餘電量
25%75%
50%100%
Recharge your PowerCore
PowerCore本体の充電
给您的PowerCore充电
為您的PowerCore充電
Slide to switch o AC output before recharging your
PowerCore.
本体充電をする前にAC出力スイッチをスライドしてオフにし
てください。
给您的PowerCore充电前请滑动关闭AC输出。
為您的PowerCore充電前請滑動關閉AC輸出。
* Solar charger (not included)
()
太阳能充电器 (另购)
()
Charge your external devices
给外部设备充电
為外部設備充電
* Slide AC output switch to start / stop charging
AC /
滑动AC输出开关,开始 / 停止充电
AC /
* Slide to switch o AC output after each use. Failure to do so will
result in battery exhaustion.
AC
每次使用后,请滑动关闭AC输出。否则会导致电池耗尽。
AC
For FAQs and more information, please visit:
@Anker
@Anker Japan
@AnkerOfficial
@Anker_JP
@Anker
Product Number A1380
External Battery / Portable Charger
SM-A474-V02
anker.com/support
5 6 7 8 9 10
While recharging PowerCore, you can charge external
devices via USB output but not AC output.
PowerCoreUSB
AC
在给PowerCore充电时,您可以通过USB输出为外部设备充电,但不
能通过AC输出充电。
在為PowerCore充電時,您可以通過USB輸出為外部設備充電,但不
能通過AC輸出充電。
PowerCore’s AC output won’t work when the external
device’s input exceeds 90W.
PowerCore AC90W
当外部设备的输入功率超过90W 时,PowerCoreAC 输出将不
工作。
當外部設備的輸入超過90W時,PowerCoreAC輸出將不工作。
If 4 LED indicators flash simultaneously while charging
external devices, slide to switch on AC output or press power
button for another time, then try again.
4 LEDAC
如果在给外部设备充电时,4LED指示灯同时闪烁,请再次滑动以
打开AC输出或按电源键,然后重试。
如果在為外部設備充電時,4LED指示燈同時閃爍,請再次滑動以
打開AC輸出或按電源按鈕,然後重試。
Specifications
| 产品参数 | 產品規格
Capacity
| 容量 | 容量
22000 mAh / 84.7Wh
DC input
| DC输入 | DC輸入
17.6 V 3 A
Output
| 输出 | 輸出
AC: 110 V ~ 60 Hz, 0.79 A, 90 W
USB: 5 V
4.2 A (3 A Max Per Port)
Operating temperature
| 工作温度
工作溫度
-10~45
Recharging temperature
充电温度 | 充電溫度
0~60
Size
| | 尺寸
182 x 124 x 31 mm / 7.2 x 4.9 x 1.2 in
Weight
| | 重量
730 g / 25.7 oz
AC power adapter
AC | AC电源适配器 | AC電源適配器
Input
| 输入 | 輸入
100-240 V ~ 50/60 Hz, 1.5A
Output
| 输出 | 輸出
17.6 V 2.2 A
Attention
| 注意 | 注意
Avoid dropping.
避免跌落产品。
避免跌落產品。
Do not expose to liquids.
请勿接触液体。
請勿接觸液體。
Keep away from flammable or explosive objects.
远离易燃易爆物品。
遠離易燃或易爆物品。
Use only power supplies listed in this manual.
仅使用本说明书中列出的电源。
僅使用本說明書中列出的電源。
Use original or certified cables.
使用原装或者通过认证的线材。
使用原裝或認證電纜。
Do not disassemble.
请勿拆卸。
請勿拆卸。
Avoid extreme temperatures.
避免在过高或过低温环境使用。
避免在過高或過低溫環境使用。
Please dispose of batteries and electronic goods in
accordance with local regulations.
请遵守当地各项相关法规处理废旧电池或设备。
請按照當地法規處理電池和電子產品。
To preserve battery lifespan, use and recharge at least
once every 4 months.
4
为保证电池使用寿命,请每四个月至少使用并充电一次。
為保持電池壽命,請每四個月至少使用一次並充電。
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment and
receiver. (3) Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected. (4) Consult the dealer or
an experienced radio/TV technician for help.
Customer Service
| 客服支持 | 客服支援
18-month limited warranty
18 | 18个月质保期 | 享有18個月保固期
Lifetime technical support
| 终身客服支持 |
support@anker.com
1-800-988-7973 | Mon-Fri 9:00-5:00 PST
(
US
)
03-4455-7823 | Mon-Fri 9:00-17:00
( 日本 )
400-0550-036 | Mon-Fri 9:00-17:30
( 中国 )
  • Page 1 1
  • Page 2 2

Anker PowerCore AC User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages