2. Industrial & lab equipment
  3. Measuring, testing & control
  4. Traceable
  5. 6406

Traceable 6406 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Traceable 6406 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
SPECIFICATIONS
Range: 14.0to230.0°F/-10.0to110.0°C
Resolution: 0.1°
DisplayUpdateRate:10seconds

OPERATION
1. Attachtheprobeandsecuretheconnection
bytightening.Theconnectorandplugare
keyed.Makecertainthattheplugisinserted
correctly,donotinserttheplugincorrectly
andforceit.
2. Pressthe buttontoturntheuniton.
3. Inserttheprobeintothematerialtobe
measuredandreadthedisplay.
4. Pressthe buttontoturntheunitoff.To
conservebatterylife,alwaysturntheunitoff
whennotinuse.
SELECTING °F OR °C
1. Pressthe buttontoturntheunitoff.
2. Pressandholdthe buttonfor8seconds.
3. Continuetopressthe buttonwhenthe
displayshowsareading.Thedisplaywill
alternatebetweenshowingthetemperature
in°Fand°C.
4. Releasethe buttononcethedesired
measurementunitisdisplayed.
DISPLAY MESSAGES
E02 Indicatesthatthetemperaturebeing
measuredisbelowthemeasurement
rangeofthethermometerorthatthe
probeand/orcablehasbeendamaged.
E03 Indicatesthatthetemperaturebeing
measuredisabovethemeasurement
rangeofthethermometerorthatthe
probeand/orcablehasbeendamaged.
E31 Indicatesthattheelectronicshavebeen
damaged.
PROBE USE
Theprobeissuppliedwithaholderandferrel.The
ferrelmaybetightenedsothatwhileusingwiththe
holdertheprobemaybesetatthedesireddepth.
Theprobeandcablearewaterproof;however,for
extendedmeasurementperiods,donotleavethe
probehandleandcablesubmersed.Utilizethe
holderandferrelforextendedmeasurement.
Control Company Cat. No. 6406
Traceable
®
is a registered trademark of Control Company.
©2016 Control Company. 92-6406-00 Rev. 1 062016
®
WALL MOUNT HANGER
ALL OPERATIONAL DIFFICULTIES
Ifthisthermometerdoesnotfunctionproperlyfor
anyreason,replacethebatterieswithnewhigh
qualitybatteries(seethe"BatteryReplacement"
section).Lowbatterypowercanoccasionally
causeanynumberof"apparent"operational
difficulties.Replacingthebatterieswithnew
freshbatterieswillsolvemostdifficulties.
BATTERY REPLACEMENT
Erraticreadings,afaintdisplay,nodisplayor
appearingonthedisplayareallindications
thatthebatteriesmustbereplaced.Removethe
batterycoverbyremovingthesixbatterycover
screws.Removetheexhaustedbatteriesand
replacethemwith4newAAAAlkalinebatteries.
Makecertaintoinstallthenewbatteriesinthe
directionsindicatedinthebatterycompartment
(improperbatteryplacementmaycausedamage
totheelectronics).Replacebatterycoverand
tightenthe6screwssecurely.
TRACEABLE
EXTRA-LONG
PROBE
WATERPROOF
THERMOMETER
INSTRUCTIONS
WARRANTY, SERVICE, OR RECALIBRATION
Forwarranty,service,orrecalibration,contact:
CONTROL COMPANY
12554 Old Galveston Rd. Suite B230
Webster, Texas 77598 USA
Ph. 281 482-1714 • Fax 281 482-9448
E-mail [email protected] • www.traceable.com
Control Company is ISO 9001:2008 Quality-Certied
by DNV and ISO/IEC 17025:2005 accredited as a
Calibration Laboratory by A2LA.
/