Traceable 6406 Owner's manual

Category
Measuring, testing & control
Type
Owner's manual
SPECIFICATIONS
Range: 14.0to230.0°F/-10.0to110.0°C
Resolution: 0.1°
DisplayUpdateRate:10seconds

OPERATION
1. Attachtheprobeandsecuretheconnection
bytightening.Theconnectorandplugare
keyed.Makecertainthattheplugisinserted
correctly,donotinserttheplugincorrectly
andforceit.
2. Pressthe buttontoturntheuniton.
3. Inserttheprobeintothematerialtobe
measuredandreadthedisplay.
4. Pressthe buttontoturntheunitoff.To
conservebatterylife,alwaysturntheunitoff
whennotinuse.
SELECTING °F OR °C
1. Pressthe buttontoturntheunitoff.
2. Pressandholdthe buttonfor8seconds.
3. Continuetopressthe buttonwhenthe
displayshowsareading.Thedisplaywill
alternatebetweenshowingthetemperature
in°Fand°C.
4. Releasethe buttononcethedesired
measurementunitisdisplayed.
DISPLAY MESSAGES
E02 Indicatesthatthetemperaturebeing
measuredisbelowthemeasurement
rangeofthethermometerorthatthe
probeand/orcablehasbeendamaged.
E03 Indicatesthatthetemperaturebeing
measuredisabovethemeasurement
rangeofthethermometerorthatthe
probeand/orcablehasbeendamaged.
E31 Indicatesthattheelectronicshavebeen
damaged.
PROBE USE
Theprobeissuppliedwithaholderandferrel.The
ferrelmaybetightenedsothatwhileusingwiththe
holdertheprobemaybesetatthedesireddepth.
Theprobeandcablearewaterproof;however,for
extendedmeasurementperiods,donotleavethe
probehandleandcablesubmersed.Utilizethe
holderandferrelforextendedmeasurement.
Control Company Cat. No. 6406
Traceable
®
is a registered trademark of Control Company.
©2016 Control Company. 92-6406-00 Rev. 1 062016
®
WALL MOUNT HANGER
ALL OPERATIONAL DIFFICULTIES
Ifthisthermometerdoesnotfunctionproperlyfor
anyreason,replacethebatterieswithnewhigh
qualitybatteries(seethe"BatteryReplacement"
section).Lowbatterypowercanoccasionally
causeanynumberof"apparent"operational
difficulties.Replacingthebatterieswithnew
freshbatterieswillsolvemostdifficulties.
BATTERY REPLACEMENT
Erraticreadings,afaintdisplay,nodisplayor
appearingonthedisplayareallindications
thatthebatteriesmustbereplaced.Removethe
batterycoverbyremovingthesixbatterycover
screws.Removetheexhaustedbatteriesand
replacethemwith4newAAAAlkalinebatteries.
Makecertaintoinstallthenewbatteriesinthe
directionsindicatedinthebatterycompartment
(improperbatteryplacementmaycausedamage
totheelectronics).Replacebatterycoverand
tightenthe6screwssecurely.
TRACEABLE
EXTRA-LONG
PROBE
WATERPROOF
THERMOMETER
INSTRUCTIONS
WARRANTY, SERVICE, OR RECALIBRATION
Forwarranty,service,orrecalibration,contact:
CONTROL COMPANY
12554 Old Galveston Rd. Suite B230
Webster, Texas 77598 USA
Ph. 281 482-1714 • Fax 281 482-9448
E-mail [email protected] • www.traceable.com
Control Company is ISO 9001:2008 Quality-Certied
by DNV and ISO/IEC 17025:2005 accredited as a
Calibration Laboratory by A2LA.
  • Page 1 1
  • Page 2 2

Traceable 6406 Owner's manual

Category
Measuring, testing & control
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI