A- Conduit Entry
• The 1.75” knockouts on the top and bottom accommodate 1.25”
conduit.
B- Platform Attachment Slot
• (8) Attachment points on the 30”, (12) Attachment points on the 42”
C- Module Attachment Holes
D- Enclosure Mounting Locations
• Drive screws into the open screw slots located along the sides of
the enclosure.
E- Surface Mount Holes
F- Removable Conduit Knockout Panel & Single Gang Knockouts
• Large panel for Wattbox. Follow the installation instructions
included with the WB-200-VB (sold separately).
G- Drywall Markings
• Drywall hole markings indicate 1/2”, 5/8”, or 3/4”. depths.
• Standard hole track at the center allows for easier installation once
in place.
Note: Once installed, place the protective drywall cover on to protect
the enclosure during drywalling.
Wirepath Plastic Enclosures
A
B
C
E
F
G
D
WP-ENCL-30 WP-ENCL-42
Hardware Pack 1 1
Grommets 6 6
*Hardware Pack and grommets not shown
Thank you for purchasing a great product from Wirepath Structured Wiring. The Wirepath
Plastic Enclosure is designed to provide the most exibility for your equipment installation.
G
½˝
⅝˝
¾˝
WARNING: ELECTRICAL SHOCK HAZARD! Cutting or drilling into
electrical wires or cables can cause death or serious personal injury!
ALWAYS make certain the area behind mounting surfaces is free of
electrical wires and cables before cutting, drilling, or installing fasteners.
DANGER: IMPROPER WIRING CAN LEAD TO DEATH OR SEVERE
PERSONAL INJURY! Grounding must be installed by qualied personnel
using a UL Recognized No. 12 AWG Green and Yellow grounding wire
connected to the grounding lug on the enclosure. Proper grounding of the
unit should be veried by a waulied electrician and compliant with the
National Electrical Code.
!
!