2. WeatherTech
  3. 81BS1

WeatherTech 81BS1 Installation guide

  • Hello! I've reviewed the instructions for the WeatherTech BumpStep. This document provides step-by-step guidance on installing the hitch-mounted bumper protection device, ensuring its proper alignment and securing it with a hitch pin. It also emphasizes the importance of inspecting the BumpStep for damage after an impact. I'm ready to answer any questions you have about its installation or usage.
  • How do I install the BumpStep?
    How do I align the BumpStep?
    How to secure the BumpStep?
    What should I do if the BumpStep has been in an accident?
Instructions
©2013 by MacNeil IP LLC
Note: If your BumpStep™ has been involved
in an impact or accident it is important to
have it inspected for cracks or fractures
prior to placing any weight or loads upon it.
Please send it to WeatherTech®, BumpStep™
Inspection, 1 MacNeil Court, Bolingbrook,
IL 60440 and we will be happy to inspect it
and advise you if it needs to be replaced.
Fully warranted to the original owner against
defects in materials and workmanship for
the lifetime of the product and specifically
excludes damage caused by impacts,
damage from car wash chemicals, etc.
Slide the 2" square portion of your
BumpStep™ into your 2" receiver
with the grooved step surface
facing upwards.
1Align the BumpStep™ to the deepest
hole position allowed by your receiver.
2
Insert the WeatherTech® hitch pin
(or any commercially available
hitch pin) to secure your BumpStep™
to the receiver.
3
Questions? Call customer service at 630 769 1500
Monday - Friday: 9 a.m. to 5 p.m. Central Time Made in USA
HitcH Mounted BuMper protection
BumpStep
™
/