MORryde JP54-017 Installation guide

  • Hello! I've reviewed the installation instructions for the Quadratec Spare Tire Carrier JP54-017. The document details how to install the new carrier, adjust it for different tire sizes, and connect the third tail light. The carrier offers two positions, and can be used even if you have a reinforced tailgate. It support up to 40" tires. I am ready to answer your questions about this product.
  • What is the maximum tire size supported by this carrier?
    Is tailgate reinforcement required to install this carrier?
    How much higher does the carrier sit in each position?
INSTALLING YOUR SPARE
TIRE CARRIER (JP54-017)
REPLACEMENT
SCREWS TO ATTACH
3RD TAIL LIGHT
INSTALL SPACERS
BETWEEN 3RD
TAIL LIGHT AND
ADJUSTABLE
SUPPORT
ADJUST HEIGHT OF SUPPORT
BASED ON TIRE SIZE
IF THE HIGHER POSITIONS ARE
USED THE WIRES FOR
THE LIGHT WILL NEED
LENGTHENED
USE STOCK JEEP HARDWARE
TO CONNECT TIRE CARRIER
TO TAILGATE
IF BEING USED WITH
TAILGATE REINFORCEMENT
THEN USE HARDWARE SUPPLIED
WITH THAT KIT
TIRE CARRIER CAN BE CONNECTED
IN ONE OF TWO POSITIONS TO
ADJUST FOR TIRE SIZE
IN LOWER POSITION CARRIER
IS 2.5 INCHER HIGHER THAN
STOCK AND 3.5 INCHES HIGHER
IN THE UPPER POSITION
1. Remove stock spare tire carrier.
2. Remove 3rd tail light from
stock carrier.
3. Attach lower portion of adjustable
light support to the top of the tire
carrier with provided hardware.
4. Bolt carrier to tailgate using stock
Jeep hardware. If using with
tailgate reinforcement then use
the hardware provided with that kit.
5. Attach upper portion of light
support to the lower portion.
Select a position that will allow
the light to be seen over the top
of spare. Max tire size of 40".
6. Route the wires for the light
through the hole in the top of
the carrier. Depending on the
adjusted location of the light
support the wires for the light
may need to be lengthened.
7. Attach 3rd tail light assembly to
upper portion of adjustable light
support using provided screws
and spacers.
/