Ergotron 45-437-216 Owner's manual

Category
Flat panel wall mounts
Type
Owner's manual

This manual is also suitable for

1 of 9
888-45-341-G-00 rev. F • 04/16
User's Guide - English
Guía del usuario - Español
Manuel de l’utilisateur - Français
Gebruikersgids - Deutsch
Benutzerhandbuch - Nederlands
Guida per l’utente - Italiano
Användarhandbok - svenska
MX mini Wall Mount
13mm
Ø 3/8” (10mm)
Ø 3/16" (5mm)
ENGLISH
For the latest User Installation Guide please visit: www.ergotron.com
User's Guide
Tools Needed
WOOD
CONCRETE
2 of 9
888-45-341-G-00 rev. F• 04/16
ABC
1
2
3
4
1x
1x
2x
4x
5x M4 x 10mm
M4 x 10mm
15x8.5x1mm
2x 2x
M8 x 80mm
2x
M8
4x
#8-32x 1/2”
1x
3/32”
ENGLISH
These symbols alert users of a safety condi-
tion that demands attention. All users should
be able to recognize and understand the
signi cance of the following Safety Hazards
if encountered on the product or within the
documentation. Children who are not able
to recognize and respond appropriately to
Safety Alerts should not use this product with-
out adult supervision!
Hazard Symbols
Review Symbol Signal Word Level of Hazard
NOTE A NOTE indicates important information that helps you
make better use of this product.
CAUTION
A CAUTION indicates either potential damage to
hardware or loss of data and tells you how to avoid the
problem.
WARNING A WARNING indicates either potential for property dam-
age, personal injury, or death.
ELECTRICAL
An Electrical indicates an impending electrical hazard
which, if not avoided, may result in personal injury,  re
and/or death.
Safety
Warning: Because mounting surface materials can vary widely, it is imperative that you make sure mounting surface is strong
enough to handle mounted product and equipment.
Caution:
To avoid the potential to pinch cables it is important to follow the cable routing instructions in this manual. Failure to follow
these instructions may result in equipment damage or personal injury.
Components
3 of 9
888-45-341-G-00 rev. F • 04/16
45.08”
(114.5cm)
5’ - 6’
(152 - 183cm)
6”
(152 mm)
5’ - 6’3”
(152 - 190.5cm)
29.58”
(75.1cm)
17.29”
(439 mm)
9.81”
(249 mm)
4.62”
117 mm)
4.61”
(117 mm)
.91”
(23 mm)
18.15”
(461 mm)
15.86”
(403 mm)
ENGLISH
This mounting height is a recommendation for an ergonomic workstation that accommodates user heights of 5'0” - 6'0”
(152 - 183cm) when set up for standing and user heights of 5’0” - 6’3” (152 - 190.5cm) when set up for sitting.
If user heights are di erent than this, you should change mounting height to accommodate user heights.
(Change mounting height one inch for every one inch di erence in user heights).
Mounting height assumes
there is a 6” (152 mm) distance
between the center of your
monitor mounting holes and
the top of the screen.
If your distance is smaller, you
should increase mounting
height accordingly, if your
distance is larger, you should
decrease your mounting
height accordingly.
Mounting Height for Ergonomic Workstation
17.29”
(439 mm)
9.81”
(249 mm)
4.62”
117 mm)
4.61”
(117 mm)
.91”
(23 mm)
18.15”
(461 mm)
15.86”
(403 mm)
Determine mounting location:
Front view with arm pushed back against the wall.
Top view showing range of motion when pulled out from the wall.
4 of 9
888-45-341-G-00 rev. F• 04/16
8 lbs. (3.6 kg)
12.6”
(320 mm)
90°
180°
360°
180°
Portrait/Landscape Rotation.
Side View
Side View
Top View
Top View Top View
Front View
ENGLISH
Features & Speci cations
CAUTION: DO NOT EXCEED MAXIMUM LISTED
WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY
DAMAGE MAY OCCUR!
5 of 9
888-45-341-G-00 rev. F • 04/16
2
7
6
M3 x 5mm
1
4x
4x
M4 x 10mm M4 x 10mm
4x
8-32 x 1/2”
ENGLISH
Choose Mounting Method
Wood
Concrete
Ergotron product.
NOTE: Wall Track and Brackets sold separately.
NOTE: VESA plate will only
accept 75mm or 100mm
VESA pattern.
Attach Display
Remove Stop Screw if you would like Portrait/Landscape Rotation.
6 of 9
888-45-341-G-00 rev. F• 04/16
ab
cd
bc
d
e
a
e
2x 15x8.5x1mm 2x
2x 15x8.5x1mm 2x M8
2x
13mm
13mm
6
6
M8 x 80mm
M8 x 80mm Ø 3/8” (10mm)
Ø 3/16" (5mm)
ENGLISH
Concrete
Wood
7 of 9
888-45-341-G-00 rev. F • 04/16
3
a
5
4
2x
b1x
M4 x 10mm
ENGLISH
NOTE: Leave enough slack in cable to allow full
range of motion.
Caution: To avoid the potential to pinch cables it is
important to follow the cable routing instructions in
this manual. Failure to follow these instructions may
result in equipment damage or personal injury.
8 of 9
888-45-341-G-00 rev. F• 04/16
a
b
c
10mm
+
_
ENGLISH
Increase Friction
If this product moves too easily, then
you'll need to increase friction:
Decrease Friction
If this product is too dif cult to move,
then you'll need to decrease friction:
Adjustment Step
You may need to adjust this arm over time as the friction pivot could change tension.
9 of 9
888-45-341-G-00 rev. F • 04/16
© 2015 Ergotron, Inc. All rights reserved.
ENGLISH
For local customer care phone numbers visit: http://contact.ergotron.com
NOTE: When contacting customer
service, reference the serial number.
Learn more about ergonomic computer use at:
www.computingcomfort.org
Set Your Workstation to Work For YOU!
Height Position top of screen slightly below eye level.
Position keyboard at about elbow height with wrists at.
Distance Position screen an arm's length from face—at least 20” (508mm).
Position keyboard close enough to create a 90˚ angle in elbow.
Angle Tilt screen to eliminate glare.
Tilt the keyboard back 10° so that your wrists remain at.
To Reduce Fatigue
Breathe - Breathe deeply through your nose.
Blink - Blink often to avoid dry eyes.
Break • 2 to 3 minutes every 20 minutes
• 15 to 20 minutes every 2 hours.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Ergotron 45-437-216 Owner's manual

Category
Flat panel wall mounts
Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI