2. Premier Mounts
  3. PP-ITC1016C
PP-ITC1016C

Premier Mounts PP-ITC1016C, PP-ITC48C, PP-ITC48P Operating instructions

  • I have reviewed the provided document detailing the installation instructions for Touchboards' PP-ITC48 and PP-ITC1016 Pipe Fitting Clamps. This document explains how to attach pipes to I-beams using these clamps, including adjusting the truss, securing the pipe, and offers load capacity information. I'm ready to answer your questions regarding this device installation.
  • What is the first step of installation?
    How do you secure the truss beam?
    What is the weight capacity of the clamps?
PP-ITC48 & PP-ITC1016
“I” BEAM & TRUSS PIPE FITTING CLAMPS
INSTALLATION INSTRUCTIONS
Step 1:
Chose were the truss would be located. Unscrew the adjustable nuts to expand the truss to fit over the “I” beam.
Step 2
Secure the truss beam by screwing the adjustable nuts against the truss. The center point of the thread pipefittings can be positioned
anywhere along the open thread path of the “all thread” rods with positive locking of the set position. (Do not over tight).
PP-ITC48C/PP-ITC-1016C2
Secure the 1-1/2” or 2” pipe to the pipe coupling style then secure the Allen socket to the pipe.
PP-ITC48P/PP-ITC1016P2
Secure the mount or the coupling to the nipple and secure the Allen screw on the coupling to the pipe.
These new clamps can easily support weights up to 175 lbs. (1 ½”) fittings and 350 lbs. (2”) fittings properly installed by qualified
personnel.
www.touchboards.com 205 Westwood Ave.Long Branch, NJ 07740 1-866-942-6273 [email protected]
/