Certa CTACZK3631A User guide

Type
User guide
PORTABLE AIR COMPRESSOR
PUMP TYRE INFLATOR
CTACZK3631A
Read these instructions carefully before using this product for the first time. Retain this user
guide for future reference.
This product is suitable for the inflation of small cars tires, motorcycle tire, bicycle tire,
balls, swimming rings and other inflatables.
This product is not suitable for use in large trucks.
This product is only applicable with 12V sockets. Do not use it with 24V sockets.
The product and hose can get hot during extended usage.
To avoid over-inflation and potential injuries, always confirm the required air pressure of
the item before inflating.
Avoid storing this product in high temperature environments.
Do not bend or step on the hose during inflation.
Do not leave the product unattended during operation. Always pay attention to avoid
over-inflating.
Do not expose the product to moisture, heavy falls, water immersion and mud or sand
ingress.
This product contains a DC motor which may generate electric sparks during operation.
Do not place it near flammable liquids or gases during operation.
Ensure the product is stored between -10°C ~ 45°C.
Excessive heat or cold will shorten the life of the product and damage the battery.
This product is not a toy. Do not allow children to play with it.
Ensure children and pets are supervised and kept at a safe distance during operation.
Before setting the air pressure value, ensure that you have selected the correct unit of
measurement, otherwise it may lead to over-inflation and potential injury.
Do not dismantle or modify this product in any way.
SAFETY & WARNINGS
Air nozzle (x2)
Ball adapter
Spare fuse
Presta valve adapter
Inflation hose
ACCESSORIES
1
Handle
5
Light button
2
Control panel
6
Power switch
3
LED light
7
12V Connector
4
Air hose
Control Panel
OVERVIEW
1
2
3
4
5
6
7
Current Air Pressure
Unit Button
Decrease button
Unit display
Increase button
M
KGF/CM²
Inflating Tyres
1. Prepare the Compressor:
Connect the portable compressor to a 12V socket source, such as your vehicle’s
cigarette lighter.
Place the compressor stable surface near the tyre you wish to inflate.
2. Attaching the inflation hose:
Attach the inflation hose to the air hose on the compressor.
Ensure that the connection is tight and free from leaks.
3. Set the Desired Pressure:
Refer to the tyre's recommended pressure, typically indicated on the tire sidewall or in
your vehicle’s manual.
Place the power switch in the ON position.
The compressor will start running, and you should hear air flowing.
Press the unit button “M” to switch the pressure units.
Use the increase “+” and decrease “-” buttons to set the desired air pressure. Wait for
the display to stop flashing.
4. Inflate the Tire:
Place the nozzle onto the tyre's valve stem, ensuring
a secure connection.
Monitor the digital display as the tire inflates.
The compressor will stop automatically once the set
pressure is reached.
5. Check the Pressure:
Detach the hose from the tyre’s valve stem.
Use a separate tire pressure gauge to verify that the tire pressure matches the desired
level.
Repeat steps 2-6 if necessary.
OPERATION
LED Light
For convenient usage during night-time or in poorly lit areas, the compressor is equipped
with a built-in LED light.
To turn the LED light ON, press the light button.
To turn the LED light OFF, press the light button again.
Accessories
As per your requirement, attach one of the included adapters to the inflation hose:
Adapter
Usage
Presta valve adapter:
Allows you to switch a Presta valve to a Schrader valve.
Suitable for mountain bikes, electric bikes, motorcycles.
Narrow inflating adapter:
Suitable for most inflatables, swimming rings, air mattresses.
Short inflating adapter:
Suitable for balloons.
Ball adapter:
Suitable for basketballs, footballs and other kinds of balls.
Air Pressure Guide
In order to maintain user safety and avoid over or under inflating items, always check the
recommended air pressure of the product.
Below is a guide of recommended air pressure values for common products.
Category
Product Type
Recommended Pressure Range
Bicycle
Folding bicycle tire
12, 14, 16-inch bicycle tire
20, 22, 24-inch bicycle tires
26, 27.5, 29-inch bicycle tire
700c road bike open tire
700c highway support lower tube tire
45-50psi
30-50psi
40-50psi
45-65psi
100-130psi
120-145psi
Motorcycle
Motorcycle tire
26-43psi
Car
Small car tire
31-40psi
Ball
Basketball
Football
Volleyball
Rugby
7-9psi
8-16psi
4-5psi
12-14psi
Replacing the Fuse
1. Unscrew the cap on 12V connector.
2. Take out the used fuse and replace it with a new fuse.
3. Replace the cap on the 12V connector.
Input Voltage
DC 12V
Power
100W
Wire Length
3m
Cylinder Diameter
22mm
MAX Air Pressure
150PSI
Problem
Cause
Solution
The compress will start
Ensure that the compressor
is properly connected to the
power source
Connect the 12V connector
to a 12V socket.
There is insufficient supply
voltage
Try using another 12V
socket.
The fuse is blown
Replace it with a new fuse.
The compressor starts, but
there is no pressure
Loose hose connections
Check the air hose and
adapter, replacing them if
necessary.
The LED light won't turn on
The compressor is not
properly connected to the
12V socket
Connect the 12V connector
to a 12V socket.
SPECIFICATIONS
TROUBLESHOOTING
NOTES
Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Certa CTACZK3631A User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI