P.I. Engineering
101 Innovation Parkway, Williamston, MI 48895-1663
(517)655-5523 FAX (517)655-4926
www.piengineering.com PI#1431
X-keys Pendant Switches
4, 6, or 8 buttons
Dust and water resistant enclosure
Relegendable buttons with clear protective caps and tactile feel switches
Compatible with X-keys HD15 USB Wire Interface
Uses standard HD15 connector and compatible cables
Connect the pendant switch to the X-keys XH15 USB Wire Interface with an
HD15 extension cable. Please note, some VGA monitor cables do not have all
wires connected and so may not work for this application.
A small flat bladed screwdriver or similar item may be used to pry off the clear
button cover so that a legend may be applied underneath. Use the included
legends or hand write on the blank legend stickers. Reattaching the cover will
protect the legend from wear.
All switches are single contact, normally open.
Wiring Pinout
HD15 Connector
Female connector on the pendant
Pin
Connection
1
Button 1
2
Button 2
3
Button 3
4
Button 4
5
Button 5
6
Button 6
7
Button 7
8
Button 8
9
Not connected
10
Common for buttons 1-8
11 - 15
Not connected
/
