Carry the SmartStep
™
Pedometer anywhere!
Put it in your pocket or purse, or hang
it from the included lanyard. It will
track steps and miles traveled, plus
calories and fat grams burned. It even
resets itself at midnight, plus tracks
your progress for seven days.
BATTERY PRECAUTIONS
Dispose of the old battery
properly. Do not dispose of
the old battery in a fire.
Do not leave the battery where
a child or pet could play with
or swallow it. If the battery is
swallowed, contact a
physician immediately.
The battery may explode
if mistreated. Do not attempt
to recharge or disassemble
the battery.
Use only a fresh battery of
the required size and type.
SAVE THESE INSTRUCTIONS
•
•
•
•
623496_INS0510_SmartStep Pedometer
Instructions Doc. Size: 300mm W x 115mm H Folded Size: 50mmW x 115mmH
Output at 100% Prints 1/1 Black Finishing: Trim to Crops; Accordian Fold: 5 folds
623496
Merrimack, New Hampshire, USA 03054
800-846-3000 • www.Brookstone.com
SmartStep
™
Pedometer
ACCURATE—ANYWHERE
YOU CARRY IT
LOCATION Of CONTROLS OPERATION
Your SmartStep
™
Pedometer comes
with a battery already installed.
Remove the plastic strip from the
BATTERY COMPARTMENT by
pulling the tab and sliding it out from
between the battery contacts.
fIRST TImE SET-UP
1. Press and hold the SET button until
the LCD SCREEN shows all zeros
and the hour number blinks.
2. Set the hour by using the
MEMORY/ and MODE/
buttons to scroll through the
numbers. Holding down either the
MEMORY/ or MODE/ button
will scroll through the numbers
rapidly. Press the SET key to
select the hour.
3. The minute number will blink
on the LCD screen.
4. Set the minutes by using the
MEMORY/ and MODE/
buttons to scroll through the
numbers. Holding down the
MEMORY/ or MODE/
button will scroll through the
numbers rapidly. Press the SET
key to select your minutes.
Note: The SmartStep
™
Pedometer
uses 24 hour (military time) to
allow for daily reset.
5. The weight number will blink
on the LCD screen.
6. Set your weight by using the
MEMORY/ and MODE/
buttons to scroll through the
numbers. Holding down the
MEMORY/ or MODE/
button will scroll through the
numbers rapidly. Press the SET
key to select your weight.
7. The stride number will blink
on the LCD screen.
SETTING STEP/STRIDE LENGTH
You must set your step/stride length
in the pedometer for it to accurately
calculate distance traveled.
1. Take five steps or strides and
measure the distance covered
in inches using a tape measure.
Divide that number by five. This is
your average step/stride length.
2. Set your stride length in inches
by using the MEMORY/ and
MODE/ buttons to scroll
through the numbers. Holding
down the MEMORY/ or
MODE/ buttons will scroll
through the numbers rapidly.
3. Press the SET key to select
your stride.
1. LCD Screen
2. Read-out
Titles
3. Memory /
Button
4. Mode /
Button
5. Set Button
6. Battery
Compartment
Cover
7. Battery
Compartment
8. Open Position
9. Close Position
10. Reset Button
11. Lanyard Hole
12. Lanyard
(not shown)
1
9 11
3
6
8
7
10
2
4
5
ONE (1) YEAR LImITEd WARRANTY
Brookstone
®
warrants this product against
defects in materials and/or workmanship under
normal use for a period of ONE (1) YEAR from
the date of purchase by the original purchaser
(“Warranty Period”). If a defect arises and a
valid claim is received within the Warranty
Period, at its option, Brookstone will either
1) repair the defect at no charge, using
new or refurbished replacement parts, or
2) replace the product with a new product that
is at least functionally equivalent to the original
product, or 3) provide a store credit in the
amount of the purchase price of the original
product. A replacement product or part, including
a user-installable part installed in accordance with
instructions provided by Brookstone, assumes
the remaining warranty of the original product.
When a product or part is exchanged, any
replacement item becomes your property and the
replaced item becomes Brookstone’s property.
When a store credit is given, the original product
must be returned to Brookstone and becomes
Brookstone’s property.
Obtaining Service:
To obtain warranty service,
call Brookstone Limited Warranty Service at
1-800-292-9819. Please be prepared to describe
the product that needs service and the nature of
the problem. A purchase receipt is required. All
repairs and replacements must be authorized in
advance. Service options, parts availability and
response times will vary. You are responsible for
delivery and the cost of delivery of the product
or any parts to the authorized service center for
replacement, per our instructions.
Limits and Exclusions:
Coverage under this
Limited Warranty is limited to the United States of
America, including the District of Columbia and the
U.S. Territories of Guam, Puerto Rico, and the U.S.
Virgin Islands. This Limited Warranty applies only
to products manufactured for Brookstone that can
be identified by the “Brookstone” trademark, trade
name, or logo affixed to them or their packaging.
The Limited Warranty does not apply to any non-
Brookstone products. Manufacturers or suppliers
other than Brookstone may provide their own
warranties to the purchaser, but Brookstone,
in so far as permitted by law, provides these
products “as is.” This warranty does not apply to:
a) damage caused by failure to follow instructions
relating to product’s use or the installation of
components; b) damage caused by accident,
abuse, misuse, fire, floods, earthquake or other
external causes; c) damage caused by service
performed by anyone who is not a representative
of Brookstone; d) accessories used in conjunction
with a covered product; e) a product or part
that has been modified to alter functionality or
capability; f) items intended to be periodically
replaced by the purchaser during the normal
life of the product including, without limitation,
batteries or light bulbs; g) any product sold
“as is” including, without limitation, floor
demonstration models and refurbished items;
or h) a product that is used commercially or for a
commercial purpose.
BROOKSTONE SHALL NOT BE LIABLE
FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES RESULTING FROM THE USE
OF THIS PRODUCT, OR ARISING OUT OF
ANY BREACH OF THIS WARRANTY. TO THE
EXTENT PERMITTED BY APPLICABLE LAW,
BROOKSTONE DISCLAIMS ANY AND ALL
STATUTORY OR IMPLIED WARRANTIES,
INCLUDING, WITHOUT LIMITATION,
WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE
AND WARRANTIES AGAINST HIDDEN
OR LATENT DEFECTS. IF BROOKSTONE
CANNOT LAWFULLY DISCLAIM STATUTORY
OR IMPLIED WARRANTIES, THEN TO THE
EXTENT PERMITTED BY LAW, ALL SUCH
WARRANTIES SHALL BE LIMITED IN
DURATION TO THE DURATION OF THIS
EXPRESS WARRANTY.
Some states disallow the exclusion or limitation of
incidental or consequential damages or how long
an implied warranty lasts, so the above exclusions
or limitations may not apply to you. This warranty
gives you specific legal rights and you may also
have other rights, which vary from state to state.
YOU ARE REAdY TO gO!
Just put the SmartStep
™
Pedometer
in your pocket or purse, or hang
from the included lanyard, and the
pedometer will automatically activate
when you start moving. If you are
going for a jog, affix the SmartStep
™
Pedometer at waist height for the
most accurate information tracking.
REAdINg YOUR RESULTS
TODAY’S INFORMATION
To read today’s information, press
MODE / to scroll through the
steps, miles, calories burned and fat
grams burned.
While viewing miles, the duration of
your activity time will appear in the
lower left hand corner.
ACCUMULATED INFORMATION
To scroll through the total of
accumulated information, press
and hold the MODE/ button
while in Step Mode until you see
the indicator arrow below TOTAL
on the LCD SCREEN.
The SmartStep
™
Pedometer will
automatically scroll through the
total steps, miles and calories you
have tracked.
Press the MODE/
button
again to discontinue scrolling
the totals. The SmartStep
™
Pedometer will go back
to its counting mode.
1.
2.
3.
To see a total of tracked
information on a specific previous
day, press the MEMORY /
button while in Step Mode to
select the day (numbers 1
through 7 are shown to the right
of the time), and then press
MODE/ button to scroll through
the steps, miles, calories and
fat grams you have tracked on
that day.
Press MEMORY /
button to
scroll back to today to continue
tracking your information.
Note: The SmartStep
™
Pedometer
keeps track of your progress for up
to 7 days at a time. The maximum
step count is 999,999 steps. If this
distance is reached before 7 days,
or on the 8th day of information
tracking, the unit will drop the first
day tracked and begin a new day, so
you will always be able to see your
last 7 days of tracked information.
RESETTINg TOdAY'S TOTAL
Press and hold SET button, then
press the MEMORY / button
simultaneously.
Steps, Miles, Calories and
Grams tracked for the current
day reset to zero.
4.
5.
1.
2.
RESETTINg THE UNIT
To clear all data and personal information
and return to factory settings.
Press the RESET button on
the back of the unit with a thin,
blunt object.
The hour number will blink on
the LCD screen.
Reset the time, your weight and
your stride length by following
the instructions previously stated
in this pamphlet.
IMPORTANT: Do not use a sharp
object to press the RESET button.
This may damage the unit.
LOCkINg THE UNIT
The SmartStep
™
Pedometer allows
you to lock the buttons so they will
not be accidentally pushed while the
unit is in your purse or pocket. You
cannot use the buttons until you
unlock it.
1. To lock the SmartStep
™
Pedometer
buttons, press both the MEMORY/
and MODE/ buttons
simultaneously until you see the
appear on the LCD SCREEN.
2. To unlock the SmartStep
™
Pedometer so you can use the
buttons, press both the MEMORY/
and MODE/ buttons
simultaneously until you see the
disappear from the LCD SCREEN.
1.
2.
3.
623496_INS0510_SmartStep Pedometer
Instructions Doc. Size: 300mm W x 115mm H Folded Size: 50mmW x 115mmH
Output at 100% Prints 1/1 Black Finishing: Trim to Crops; Accordian Fold: 5 folds
3. The SmartStep
™
Pedometer will
continue to track your progress
while the unit's buttons are locked.
BATTERY REPLACEmENT
When the battery icon on the LCD
SCREEN blinks, it is time to replace
the battery.
1. Open the BATTERY
COMPARTMENT with a coin
by lining up the arrow on the
BATTERY COMPARTMENT
COVER with OPEN.
2. Remove the spent battery and
dispose of properly. Slide a new
CR2032 battery into the BATTERY
COMPARTMENT according to the
polarity indicator.
3. Place the battery door back on
the BATTERY COMPARTMENT
and twist with a coin to line up the
arrow with CLOSE to secure.
NOTE: Your settings and recorded
information will not be saved while
you are replacing the battery.
CARE ANd mAINTENANCE
Clean with a soft, dry cloth.
SPECIfICATIONS
Uses 1 CR2032 button cell
battery (included).
/
