Whirlpool WRF993FIFM Specification

WRF993FIFM
Whirlpool
Brand
Whirlpool
Model
WRF993FIFM
Category
Fridges
Type
Specification

This manual is also suitable for

PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
French Door w/Ice Dispenser Refrigerator
WRF992FIF WRF993FIF
WRF995FIF
Electrical: A 115-volt, 60 Hz, AC-only 15- or
20-amp fused, grounded electrical supply is
required. It is recommended that a separate
circuit serving only your refrigerator and
approved accessories be provided. Use an
outlet that cannot be turned off by a switch.
Do not use an extension cord.
Water: A cold water supply with water
pressure between 35 and 120 psi (241
and 827 kPa) is required to operate the
water dispenser and ice maker. If you have
questions about your water pressure, call
a licensed, qualified plumber.
NOTE: If the water pressure is less than
what is required, the flow of water from the
water dispenser could decrease or ice cubes
could be hollow or irregular shaped.
Reverse Osmosis Water Supply:
IMPORTANT: The pressure of the water
supply coming out of a reverse osmosis
system going to the water inlet valve of
the refrigerator needs to be between 35
and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system
is connected to your cold water supply,
the water pressure to the reverse osmosis
system needs to be a minimum of 40 to
60 psi (276 to 414 kPa).
IMPORTANT: This refrigerator is designed for indoor, household use only.
To ensure proper ventilation for your refrigerator, allow for a ½" (1.25 cm) of
space on each side and at the top. Allow for a 1" (2.54 cm) space behind the
refrigerator. If your refrigerator has an ice maker, allow extra space at the back
for the water line connections. When installing your refrigerator next to a fixed
wall, leave a 3¾" (9.5 cm) minimum space between the refrigerator and wall to
allow the door to swing open.
NOTE: This refrigerator is intended for use in a location where the temperature
ranges from a minimum of 55°F (13°C) to a maximum of 110°F (43°C). The
preferred room temperature range for optimum performance, which reduces
electricity usage and provides superior cooling, is between 60°F (15°C) and
90°F (32°C). It is recommended that you do not install the refrigerator near a
heat source, such as an oven or radiator.
LOCATION REQUIREMENTS
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10706341A
4/16
Model
Size
Height -
Overall
“A”
Height -
Top of
Cabinet
“B”
Depth -
Door Open
90°
“C”
Depth -
Drawer
Open
“D”
Depth -
With
Handles
“E”
Depth -
Without
Handles
“F”
Depth -
Cabinet
Only
“G”
Width -
Cabinet
“H”
Width -
Door Open
90°
“I”
31.5 cu. ft
70¼"
(178.4 cm)
68
7
/
8
"
(174.9 cm)
52
1
/
8
"
(132.4 cm)
61
5
/
8
"
(156.5 cm)
38¾"
(98.4 cm)
36
5
/
8
"
(93.0 cm)
32"
(81.2 cm)
36"
(91.4 cm)
42
5
/
8
"
(108.3 cm)
PRODUCT MODEL NUMBER PRODUCT DIMENSIONS
MFT2778EE
Electrical: A 115-volt, 60-Hz, AC-only, 15- or
20-amp fused, grounded electrical supply is
required. It is recommended that a separate
circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned
off by a switch. Do not use an extension
cord.
NOTE: Before performing any type of
installation, cleaning, or removing a light
bulb, turn the control (Thermostat,
Refrigerator or Freezer Control depending on
the model) to OFF and then disconnect the
refrigerator from the electrical source. When
you are finished, reconnect the refrigerator to
the electrical source and reset the control
(Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired
setting. See “Using the Controls.”
Water: A cold water supply with water
pressure between 30 and 120 psi (207 and
827 kPa) is required to operate ice maker
and water dispenser. If you have questions
about your water pressure, call a licensed,
qualified plumber.
IMPORTANT: The pressure of the water
coming out of a reverse osmosis system
going to the water inlet valve of the
refrigerator needs to be between 30 and
120 psi (207 and 827 kPa).
Reverse Osmosis
Water Supply: If a
reverse
osmosis water filtration system is
connected to your cold water supply, the
water pressure to the reverse osmosis
system needs to be a minimum of 40 to
60 psi (276 to 414 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10739699A
05/15
French Door with Ice Dispenser Refrigerator
Model
Number
Model
Size
Height -
Overall
“A”
Height -
Top of
Cabinet
“B”
Depth -
Doors
Open 90°
“C”
Depth -
Drawer
Open
“D”
Depth -
With
Handles
“E”
Depth -
Without
Handles
“F”
Depth -
Cabinet
Only
“G”
Width -
Cabinet
“H”
Width -
Door Open
90°
“I”
MFT2778EE 26.8 cu. ft.
70"
(177.8 cm)
68⁵⁄₈"
(174.3 cm)
48"
(121.9 cm)
47³⁄₄"
(121.3 cm)
35⁵⁄₈"
(90.5 cm)
33¹⁄₈"
(84.1 cm)
28
7
⁄₈"
(73.3 cm)
35
7
⁄₈"
(91.1 cm)
38³⁄₁₆"
(97.0 cm)
LOCATION REQUIREMENTS
3³⁄₄" (9.5 cm)
¹⁄₂" (1.25 cm)
To ensure proper ventilation for your refrigerator, allow for a
1
⁄2" (1.25 cm) space on
each side and at the top. Allow for 1" (2.54 cm) of space behind the refrigerator. If
your refrigerator has an ice maker, make sure you leave some extra space at the
back for the water line connections.
If you are installing your refrigerator next to a fixed wall, leave 3
3
⁄4" (9.5 cm)
minimum on the hinge side (depending on your model) to allow for the door to
swing open.
NOTE: This refrigerator is intended for use in a location where the temperature
ranges from a minimum of 55°F (13°C) to
a maximum of 110°F (43°C). The
preferred room temperature range for optimum performance, which reduces
electricity usage and provides superior cooling, is between 60°F (15°C) and 90°F
(32°C). It is recommended that you do not install the refrigerator near a heat source,
such as an oven or radiator.
A
overall
B
top of
cabinet
H
not incl.
handle
F
incl.
handle
E
D
cabinet
G
90˚90˚
C
I
PRODUCT MODEL NUMBER PRODUCT DIMENSIONS
MFT2778EE
Electrical: A 115-volt, 60-Hz, AC-only, 15- or
20-amp fused, grounded electrical supply is
required. It is recommended that a separate
circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned
off by a switch. Do not use an extension
cord.
NOTE: Before performing any type of
installation, cleaning, or removing a light
bulb, turn the control (Thermostat,
Refrigerator or Freezer Control depending on
the model) to OFF and then disconnect the
refrigerator from the electrical source. When
you are finished, reconnect the refrigerator to
the electrical source and reset the control
(Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired
setting. See “Using the Controls.”
Water: A cold water supply with water
pressure between 30 and 120 psi (207 and
827 kPa) is required to operate ice maker
and water dispenser. If you have questions
about your water pressure, call a licensed,
qualified plumber.
IMPORTANT: The pressure of the water
coming out of a reverse osmosis system
going to the water inlet valve of the
refrigerator needs to be between 30 and
120 psi (207 and 827 kPa).
Reverse Osmosis
Water Supply: If a
reverse
osmosis water filtration system is
connected to your cold water supply, the
water pressure to the reverse osmosis
system needs to be a minimum of 40 to
60 psi (276 to 414 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10739699A
05/15
French Door with Ice Dispenser Refrigerator
Model
Number
Model
Size
Height -
Overall
“A”
Height -
Top of
Cabinet
“B”
Depth -
Doors
Open 90°
“C”
Depth -
Drawer
Open
“D”
Depth -
With
Handles
“E”
Depth -
Without
Handles
“F”
Depth -
Cabinet
Only
“G”
Width -
Cabinet
“H”
Width -
Door Open
90°
“I”
MFT2778EE 26.8 cu. ft.
70"
(177.8 cm)
68⁵⁄₈"
(174.3 cm)
48"
(121.9 cm)
47³⁄₄"
(121.3 cm)
35⁵⁄₈"
(90.5 cm)
33¹⁄₈"
(84.1 cm)
28
7
⁄₈"
(73.3 cm)
35
7
⁄₈"
(91.1 cm)
38³⁄₁₆"
(97.0 cm)
LOCATION REQUIREMENTS
3³⁄₄" (9.5 cm)
¹⁄₂" (1.25 cm)
To ensure proper ventilation for your refrigerator, allow for a
1
⁄2" (1.25 cm) space on
each side and at the top. Allow for 1" (2.54 cm) of space behind the refrigerator. If
your refrigerator has an ice maker, make sure you leave some extra space at the
back for the water line connections.
If you are installing your refrigerator next to a fixed wall, leave 3
3
⁄4" (9.5 cm)
minimum on the hinge side (depending on your model) to allow for the door to
swing open.
NOTE: This refrigerator is intended for use in a location where the temperature
ranges from a minimum of 55°F (13°C) to a maximum of 110°F (43°C). The
preferred room temperature range for optimum performance, which reduces
electricity usage and provides superior cooling, is between 60°F (15°C) and 90°F
(32°C). It is recommended that you do not install the refrigerator near a heat source,
such as an oven or radiator.
A
overall
B
top of
cabinet
H
not incl.
handle
F
incl.
handle
E
D
cabinet
G
90˚90˚
C
I
  • Page 1 1

Whirlpool WRF993FIFM Specification

WRF993FIFM
Whirlpool
Brand
Whirlpool
Model
WRF993FIFM
Category
Fridges
Type
Specification
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents