15
English
4. Feed the cable through cable and hose opening
d
into the base cabinet.
For maintenance work, the LED light can be pushed into the prole.
7. Operation
Filling the aquarium (⌦D)
CAUTION! Material damage.
▶ Do not use hard objects or cleaning agents for cleaning.
1. Before lling, thoroughly clean the aquarium with warm water and a soft, clean sponge.
2. Decorate the aquarium with gravel, stones, plants, etc.
DANGER! Electrocution due to penetrating water!
The LED light is only protected against penetrating water if immersed temporarily.
▶ The distance from the underside of the light
f
to the highest water mark must be a minimum of
15 mm.
3. Fill the aquarium with water to a maximum of 10 mm above the lower edge of the cover frame
e
.
Switching the LED light on/o
1. To switch on the LED light, insert the power supply unit’s mains plug into the mains socket.
2. To switch o the LED light, pull out the power supply unit’s mains plug.
To switch the LED light on and o more conveniently, we recommend a timer or the EHEIM Dimmer
classicLED.
Laying on the cover (⌦E)
CAUTION! Material damage.
The covers only serve as protection against escaping condensation and light.
▶ Do not place objects on the covers from above.
The cover
g
is narrower in width than the cover
h
.
1. Lay the cover
g
in the lower sliding surface of the cover frame.
2. Lay the cover
h
in the upper sliding surface of the cover frame.
Opening/closing the cover
CAUTION! Material damage.
Condensation can form on the underside of the covers.
▶ Only open the covers by pushing them sideways or folding them back to the side.
▶ Before removing the covers, allow the condensation to drip into the aquarium.