ARTHUR MARTIN ALM4500PX Installation guide

Type
Installation guide

This manual is also suitable for

D Seite 3
F page 4
GB page 5
NL aijde 6
N side 7
I pagina 8
P pagina 9
S
DK
sida 10
sida 11
Publication no. 315 3592 06 - 2 - 03.10. RPA / AFA
GB Installation instructions.
Mikrowave-Liftdoor
Building-in fittings for front width 600
Assembly:
a)
b)
c)
Using the baseplate (G) as a template (nose of stop to the front !), mark the fixing holes
on both sides. (Fig. 4)
- Drill these approx. 2mm deep using a 2mm drilling bit.
- Now screw 1 wood screw (S 2) per side, in hole A up to approx. 5mm from the
wall (B).
- Now snap a left and right hand baseplate (G) on to both side plates.
- The 2nd baseplate (G) is required as an underlay if the niche is wider than
565mm.
Now insert the door (mounting) in the direction of the arrow between screw (A) and the
niche top. (Fig. 5)
- Take care that the mounting is flush up against the niche top (nose of stop) and
flush with the edge at the front.
- Now screw the mounting in place laterally using the 3 screws (S 2).
Now place the microwave unit in the niche with the required distance. (Fig. 6)
Right of alterations reserved.
Publication no. 315 3592 06 - 5 - 03.10. RPA/AFA
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11

ARTHUR MARTIN ALM4500PX Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI