IMPORTANT SAFETY INFORMATION
WARNING: ELECTRICAL SHOCK HAZARD – Turn off power at the main
power source by unscrewing fuse or switching circuit breaker
to the OFF position before installing, removing, or cleaning
this thermostat.
WARNING: FIRE AND ELECTRIC SHOCK HAZARD – This device should be
installed by a qualified service technician with due regard
for safety as improper installation could result in a fire and
electric shock hazard.
WARNING: FIRE AND ELECTRICAL SHOCK HAZARD – This is a 24V AC
low-voltage thermostat. Do not install on voltages higher than
30V AC.
• Donotswitchsystemtocoolifthetemperatureisbelow50°F(10°C).Thiscan
damageyourcoolingsystemandmaycausepersonalinjury.
• Donotshort(jumper)acrossterminalsonthegasvalveoratthesystemcontrol
totestinstallation.Thiswilldamagethethermostatandvoidthewarranty.
• Donotconnectgroundtoanyterminalinthisunit.
• Allwiringmustconformtolocalandnationalbuildingandelectricalcodesand
ordinances.
• Usethisthermostatonlyasdescribedinthemanual.