16
REAR-FACING INSTALLATION WITH LATCH
Adjust child restraint to recline position
(fig. a). Flip recline feet under child
restraint for rear facing use.
-AKESURE&ORWARD&ACINGLATCH belt is
stored. (see fig. c, pg. 39)
Place rear-facing ONVEHICLESEATEQUIPPED
with LATCH anchors.
&OREASEOFINSTALLATIONEXTENDLATCH belt
TOITSMAXIMUMLENGTH
(OOKCONNECTORSTOVEHICLELOWERANCHORS
(fig. b). Belt must lay flat and not be
twisted. Pull connectors to be sure they
are securely attached to the anchor points.
(fig. c).
0RESSDOWNlRMLYINCENTEROFCHILDRESTRAINT
while pulling LATCH adjustment belt. (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. e).
#HECKTHATTHELOWERANCHORBELTSTAYSTIGHT
and does not slip from the tightened position. If
ITDOESNOTSTAYTIGHTTRYANOTHERSEATING
POSITIONORCONTACT#USTOMER3ERVICE
#HECKLEVELINDICATORONCHILDRESTRAINT(fig. f).
Vehicle mustBEONLEVELGROUNDANDCHILDIN
CHILDRESTRAINTWHENCHECKINGLEVELINDICATOR
Ball MUST be entirely in green zone (fig. f). If
NECESSARYPLACEROLLEDTOWELSUNDERCHILD
RESTRAINTATVEHICLESEATCREASEUNTILENTIREBALL
ISINGREENZONE4HENRECHECKLEVELINDICATOR
DO NOT use tether rear-facing4ETHERmust be
STOREDSEEh4ETHER3TORAGEvPAGE
0ERIODICALLYCHECKTHATCHILDRESTRAINTISSECURELY
INSTALLEDANDPROPERLYLEVELEDADJUSTIFNECESSARY
4OREMOVE LATCHSEEh2EMOVINGLATCH from
6EHICLE!NCHOR0OINTSvP