Maytag MAL2424AXX User manual

Type
User manual

This manual is also suitable for

5.
2.
6.
1.
S TAC K ING K IT INS T AL L ATION
1)P osition the unit on a level s urface,
capable of supporting the entire
weight of the dryer.
R emember that the unit will be
heavier when it is fully loaded.
C lean the s urface where the stacking
kit is going to be installed.
P lace the mounting bracket on the
W as her as indicated.
2) R emove the 2 plastic covers (shown in figure 6) attached
to the middle of the s tacking kit, and save thes e for
later us e. R emove the double back tape and firmly attach
the stacking kit the top of the was her to assure the
proper seal.
Make s ure the word F R ONT printed on the s tacking kit
is facing forward as shown above.
3) P ut back edge of stacking kit to back mold line of washer
5) Your Dryer is equipped with 4 leveling legs .
Make s ure they are lowered 10 mm, so there is a
gap between the legs and the dryer base.
6) G ently pus h the dryer into position as
indicated in figure 5 & 6, sliding the unit into
the slots provided.
It is important that the dryer is level.
Make sure all four leveling legs are pushed
all the way back into the s lots to ens ure
proper mounting.
3.
6.
4) Ins tall all 7 screws provided with a power drill
and tighten the stacking kit to the unit bas e securely.
4.
8.
DC 68-01052A
7) Ins ert the plas tic covers
(removed in s ection 2)
covering the two front
slots of the leveling legs.
Depending upon the
location of the unit, it may
be necessary to change
the side on which the dryer
door opens.
7.
( back )
  • Page 1 1

Maytag MAL2424AXX User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI