Symmons 412SH Installation guide

Symmons
Brand
Symmons
Model
412SH
Category
Wall & ceiling mounts accessories
Type
Installation guide
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3081 REV 0 09/18/14
412HS, 412SH, 412W
Naru
™
Hand Shower/Showerhead/Hand Shower Wand
Operation & Maintenance Manual
Model Numbers Specifications
412HS Hand Shower Assembly
412SH Showerhead
412W Hand Shower Wand
Hand shower assembly, showerhead and hand shower
wand include standard 2.5 gpm (9.5 L/min) ow restrictor.
Components are made from metal and nonmetallic
materials plated in standard polished chrome nish.
Modifications Compliance
-1.5 1.5 gpm (5.7 L/min) flow restrictor
-2.0 2.0 gpm (7.6 L/min) flow restrictor
-PNL Polished nickel finish
-STN Satin nickel finish
-ASME A112.18.1; CSA B125.1
-WaterSense 1.5, 2.0 gpm (412SH only)
Warranty
Limited Lifetime - to the original end purchaser in
consumer installations.
5 Years - for commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Note: Append appropriate -sufx to model number.
c
Certied by
IAPMO R&T
2
Dimensions
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3081 REV 0 09/18/14
Measurements
A Ø 2 1/4", 57 mm
B 3 3/4", 95 mm
C Ø 1 1/2", 38 mm
D
Female 1/2" IPS thread
must be recessed 7/8" from
nished wall
E 3 1/4", 83 mm
F 5", 127 mm
G 3 5/8", 92 mm
H 8 1/4", 210 mm
Note:
1) Dimensions are subject to change without notice.
EE
B
B
FF
C
C
A
A
D
D
G
G
412SH
412W
412HS
HH
3
Parts Breakdown
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3081 REV 0 09/18/14
Replacement Parts
Item Description Part Number
A
J
Vacuum Breaker
60" Hose
EF-104
B
C
Wall Elbow
Wall Elbow Flange
T-444-KIT
D
E
F
G
H
Cradle Mount
Cradle Mounting Screws
Washer
Cradle Arm
Set Screw
T-545
I Hand Shower 412W
K Showerhead 412SH
Notes:
1) Append -PNL to part number for polished nickel
nish; -STN for satin nickel.
2) Append -1.5 or -2.0 to showerhead or hand shower
for low ow.
Required for Installation
Adjustable wrench
Phillips head screwdriver
Plumber tape
C
412HS
412SH 412W
I
I
A
B
J
E
D
G
K
H
F
4
Installation
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3081 REV 0 09/18/14
1) Install wall elbow
(B)
and ange (C)
to recessed pipe tting. Turn elbow
clockwise to tighten (412HS only).
2) Press tab to remove mounting
plate (D2) from cradle mount
cover (D1).
Note:
Mounting plate (D2) center
tabs must be horizontal for removal.
3) Place mounting plate
(D2)
in
position, mark and drill 1/8" pilot
holes into stud.
Option:
Place mounting plate
(D2)
in
position, mark and drill 3/16" holes
into wall. Install anchors.
4) Install mounting plate
(D2)
. Secure
with two screws
(E)
. Replace
cradle mount cover (D1).
Note: Mounting plate (D2) center tabs
must be horizontal for installation.
5) Attach cradle arm (G) and
washer (F) to cradle mount (D).
Secure with set screw (H).
6) Install showerhead
(K)
to shower
arm turning clockwise to tighten
(412SH head only).
7) Attach large end of hand
shower hose (J) to hand shower
head (I). Attach small end of hand
shower hose (J) and gasket to
in-line vacuum breaker (A).
Connect in-line vacuum breaker
to wall elbow (B). Turn clockwise
to tighten.
2
1
D1
D2
1
3
2
D2
1
3
2
E
D2
D2
D1
3
1
4
2
J
I
A
J
B
1
2
K
1
2
D2
1
2
B
C
1
2
D
H
F
G
5
Care and Cleaning
1) Clean nished trim area with a soft cloth using mild soap and water or a non-abrasive cleaner and then quickly rinse
with water.
Troubleshooting Chart
Problem Cause Solution
Finish is spotting. Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then
quickly rinse with water.
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.
■
www.symmons.com
■
[email protected]
■
ZV-3081 REV 0 09/18/14
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Symmons 412SH Installation guide

Symmons
Brand
Symmons
Model
412SH
Category
Wall & ceiling mounts accessories
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents