2. NAD
  3. MDC BluOS 2

NAD MDC BluOS 2, MDC BluOS 2i Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the NAD MDC BluOS 2 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
®
MDC BluOS 2
Mounting Instructions
WHAT’S IN THE BOX
INSTALL MDC BluOS 2
STEP A
Remove the MDC Classic cover and top cover by loosening and taking out the
screws holding them in place.
Installation location of MDC BluOS 2 (as viewed from the rear panel)
C368: Either slot
C388: Either slot
C390DD: Second slot from the left side
M12: Any of the three slots from the right side
M32: Any of the two slots from the right side
STEP B
1 Take note of the unique Wi-Fi MAC address (the same can be found on
the MDCBluOS 2 metal back plate). This is needed when conguring the
MDCBluOS 2.
2 Remove the protective tape from the contact terminals.
3 Slide MDCBluOS 2 module through the rail pushing all the way to the
corresponding connectors.
4 Make sure MDCBluOS 2 module is locked in.
Use corresponding screws to x back into place MDCBluOS 2 module and top
cover.
4
3
IMPORTANT NOTES
• Download “Conguring MDC BluOS 2” from nadelectronics.com/product/mdc-bluos-2 for instructions on how to setup your MDC BluOS 2 .
• MDC BluOS 2 can be integrated with the following compatible NAD products - C368, C388, C390DD, M12 and M32.
• The reference model used in this mounting instruction is C368.
2
1
WIRED CONNECTION*
Connect Ethernet cable (not supplied).
WIRELESS CONNECTION*
Connect dongle. If wireless connectivity is poor, connect dongle to the supplied
extension cable and straighten out for better reception.
*Requires broadband router that supports Ethernet and/or WiFi standards.
BLUETOOTH CONNECTION
Connect supplied Bluetooth antenna.
Copyright 2018, NAD Electronics International, a division of Lenbrook Industries Limited
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited.
No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.
While every effort has been made to ensure the contents are accurate at the time of publication, features and specifications may be subject to change without prior notice.
MDC DDBLUOS2_QS_V05  FEB 2018
CONNECT!
/