3
Troubleshooting
Quick Installation
3
PROBLEM SOLUTION
Your circuit breaker trips.
YourIsobarisoverloaded.
Unplugsomeequipment.Waitoneminute
whileyourIsobarcools,thenpushthe
circuitbreakerbuttonbackin.
The green “Protection Present”
and/or “Line OK” LED(s) do not
light.
Yourequipmentisnotfullyprotectedagainst
surgesorthereisawiringfaultinyourwall
outlet.
Makesurethatpowerisavailableatthe
walloutlet,thepowerswitchisonandlit,
andtheIsobariscompletelypluggedin.
The red “Fault” LED lights when
you first plug in your Isobar.
Thereisawiringfaultinyourwalloutlet.
(Phasesarereversed,groundismissing,etc.)
Haveaqualifiedelectricianfixthefault
immediately.NOTE:Aloosewalloutlet
maycausethe“Fault”LEDtolight.Your
Isobarwillidentifymostwiringfaults,but
maynotidentifyeverypossibletypeof
fault.
The red “Fault” LED lights after
continued use of your Isobar.
YourIsobarmayhavebeendamagedbya
surge.
Haveaqualifiedelectricianexamineyour
outlettodetermineifafaulthasdeveloped.
Ifnofaultexists,contactTrippLitefor
service.
Equipment plugged into the
Isobar exhibits audio static or
video “snow.”
Someequipmentmaybegeneratingelectrical
interference.
Plugyourequipmentintooutletsnot
directlyacrossfromeachotherandplug
equipmentwithheavypowerdraws(suchas
printers)intooutletsawayfrommonitors
andAVequipment.
3
Plug the power cords of your
electrical equipment into your
surge suppressor’s outlets.
DO NOT OVERLOAD the surge protector.
Each outlet can handle up to 15 amps, but
do not exceed a total load of more than 15
amps for all outlets. If the circuit breaker
trips, the outlets will cease to provide
power. Remove overload and depress
circuit breaker to reset.
PremiumsurgesuppressionandIsolatedFilter
Banktechnologyinstantaneouslystop
damagingsurgesandfilterdisruptiveEMI/
RFIlinenoise,eliminatinginterference
betweenconnectedequipment.Yourelectrical
equipmentisnowprotected.