E-flite Celectra User manual

Celectra
E-flite
Brand
E-flite
Model
Celectra
Category
Battery chargers
Type
User manual

This manual is also suitable for

E-flite Celectra is a compact and versatile 1-Port 2S 7.4V DC Li-Po Charger, designed for charging UMX 2-Cell 7.4V 120 mAh 20C Li-Po batteries. Its user-friendly design features a simple one-button operation and clear LED indicators for monitoring the charging status. It provides a safe and efficient way to charge your Li-Po batteries, ensuring they are ready for your next flight. Additionally, the E-flite Celectra is equipped with safety features like reverse polarity protection and overcharge prevention, giving you peace of mind during the charging process.

E-flite Celectra is a compact and versatile 1-Port 2S 7.4V DC Li-Po Charger, designed for charging UMX 2-Cell 7.4V 120 mAh 20C Li-Po batteries. Its user-friendly design features a simple one-button operation and clear LED indicators for monitoring the charging status. It provides a safe and efficient way to charge your Li-Po batteries, ensuring they are ready for your next flight. Additionally, the E-flite Celectra is equipped with safety features like reverse polarity protection and overcharge prevention, giving you peace of mind during the charging process.

5
EN
Charging the Battery
The Battery Charging Process
1. Charge only batteries that are cool to the touch and are not damaged. Look at the battery to make
sure it is not damaged e.g., swollen, bent, broken or punctured.
2. The connector on the battery is specifically designed to allow the battery to fit into the charge port one
way to prevent reverse polarity connection. However, check for proper alignment and polarity before
proceeding to the next step.
3. Gently press the battery connector into the charge port located on the front of the charger.
4. When you make the connection successfully, the green LED blinking on the charger slows, indicating
proper connection.
5. Press the button on the charger, the red LED will illuminate, indicating charging has begun.
6.Charging a fully discharged (not over-discharged) 120mAh battery takes approximately 25–30
minutes.
7. When battery is fully charged, the green LED will illuminate.
8. Always unplug the battery from the charger immediately upon completion of charging.
CAUTION: Overcharging a battery can cause a fire.
WARNING: Failure to use the proper charger for a Li-Po battery can result in serious damage, and if left
charging long enough, will cause a fire. ALWAYS use caution when charging Li-Po batteries.
WARNING: Selecting a charge rate higher than 2.5 times the battery capacity may cause a fire.
Your Beast comes with a Celectra™ 1-Port 2S 7.4V
DC Li-Po Charger and UMX 2-Cell 7.4V 120 mAh
20C Li-Po battery. Please visit www.horizonhobby.
com for optional battery adapters. Refer to battery
warnings. It is recommended to charge the battery
pack while you are inspecting the aircraft. The flight
battery will be required to confirm proper aircraft
operation in future steps.
LED Functions under normal operation
1. Green LED blinking with power connected but without battery .............................. Standby
2. Green LED blinking ............................................................................................... Battery is connected
3. Blinking Red LED at varying speeds ...................................................................... Charging
4. Red and Green LED blinking simultaneously .......................................................... Balancing
5. Solid Green LED .................................................................................................. Full Charge
6. Red and Green LED flashing rapidly ...................................................................... Error
  • Page 1 1

E-flite Celectra User manual

Celectra
E-flite
Brand
E-flite
Model
Celectra
Category
Battery chargers
Type
User manual
This manual is also suitable for

E-flite Celectra is a compact and versatile 1-Port 2S 7.4V DC Li-Po Charger, designed for charging UMX 2-Cell 7.4V 120 mAh 20C Li-Po batteries. Its user-friendly design features a simple one-button operation and clear LED indicators for monitoring the charging status. It provides a safe and efficient way to charge your Li-Po batteries, ensuring they are ready for your next flight. Additionally, the E-flite Celectra is equipped with safety features like reverse polarity protection and overcharge prevention, giving you peace of mind during the charging process.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents