Ergotron DM16-1003-1 User guide

Brand: Ergotron

Model: DM16-1003-1

Category: Portable device management carts & cabinets

Type: User guide

This manual is also suitable for

1 of 7

888-33-343-G-01 revB• 07/13

Reduce

Reuse

Recycle

Apple, iPad, iPhone, iPod, iPod touch, iTunes, and Macintosh are trademarks of Apple Inc., registered in the U.S. and other countries.

Table of Contents

Hazard Symbols Review ........................................................................................................................ 2

Components ........................................................................................................................................ 2

Charging Set-up .................................................................................................................................... 3-4

LED and Syncing .................................................................................................................................... 4-5

Cleaning and Maintenance.................................................................................................................... 6

Speci cations ........................................................................................................................................ 6

Service and Warranty Information ........................................................................................................ 6

User's Guide

Tablet Management

Rack 16

2 of 7

888-33-343-G-01 revB• 07/13

a) Insert power cable into bottom of tower.

b) Route cable through cable restraint.

Plug in Power Cable

Components

ABC

These symbols alert users of a safety condition that

demands attention. All users should be able to

recognize and understand the signi cance of the fol-

lowing Safety Hazards if encountered on the product

or within the documentation. Children who are not

able to recognize and respond appropriately to Safety

Alerts should not use this product without adult

supervision!

Hazard Symbols Review

Symbol Signal Word Level of Hazard

NOTE

A NOTE indicates important information that helps you

make better use of this product.

CAUTION

A CAUTION indicates either potential damage to

hardware or loss of data and tells you how to avoid the

problem.

WARNING

A WARNING indicates either potential for property dam-

age, personal injury, or death.

ELECTRICAL

An Electrical indicates an impending electrical hazard

which, if not avoided, may result in personal injury,  re

and/or death.

3 of 7

888-33-343-G-01 revB• 07/13

a) Insert tablets into racks and connect the cables that came with your mobile device.

NOTE: If desired, attach cable identiﬁ er label.

b) Connect USB Type A plug to tower and attach cable cover by snapping into place.

c) Plug tower power cord into outlet.

d) Bundle cables with velcro straps.

USB

type A

a a

Set-up racks and tower

4 of 7

888-33-343-G-01 revB• 07/13

Tablet Charging

NOTE: The power cord

acts as the connect/dis-

connect device switching

power off and on. The

socket outlet shall be

installed near the equip-

ment and shall be easily

accessible.

When used with the iPad (1st generation) and iPad 2, the ISI lights will continue to stay lit

showing the color green indeﬁ nitely after the unit is completely charged. When used with

an iPad mini, and iPad with Retina Display (4th generation), or an iPad 3 and iOS 6.0 or

later, the ISI will stay lit for approximately 15 minutes after the unit is completely charged.

At this time, the iPad will turn off to conserve battery life, so the ISI will turn off also.

NOTE: If tower is syncing all ISIs will be green.

Power Indicator – Communicates sync and charge status with the following signals:

Individual Status Indicators (ISI) – Sequentially numbered LEDs (1 - 16) corresponding

to each tablet in the tower:

LED - Indicators

To begin charging the tablets, plug in the power cord.

The power cord is used to turn the power on and off.

Charging occurs whenever the power cord is connected

UNLESS a notebook USB cable is connected for syncing.

1-16

Light Description

Off No power to the tower.

On - solid Tablets are charging.

On - slow blink Computer is plugged into USB port and tablets are ready to sync or are

syncing.

On - fast blink Fault Status. Please make sure all cables are seated correctly and product

is operating within speciﬁ ed operating temperature. Can also indicate a

failed USB cable. Contact Ergotron Customer Support if problem continues.

Light Description

Green Fully charged.

Amber

Charging in progress.

Off No device connected. (see note below)

5 of 7

888-33-343-G-01 revB• 07/13

Note: Complete the Tablet Charging instructions before starting the Syncing instructions. Tablets should be charged at

least 50% before starting the syncing process. Tablets will only receive a 0.5A charge during the syncing process.

Tablets will mount as USB devices when the included USB cable is connected to a host notebook via the USB port on the

back of the tower. To sync, follow the instructions for your particular third-party Mobile Device Management software. Files

can also be transferred manually as the devices will be identiﬁ ed as standard USB drives.

Apple Devices:

Apple iPad, iPod touch, or iPhone devices will sync to a host Macintosh computer using third-party Mobile Device

Management software, iTunes or Apple Conﬁ gurator. To sync Apple devices using iTunes or Apple Conﬁ gurator programs,

Ergotron recommends using a Macintosh computer with the latest iTunes or Apple Conﬁ gurator software.

• Mac OS X v 10.5.8 or later

• iTunes 9.1 or later (download from http://www.itunes.com/download) or Apple Conﬁ gurator

(download from the Mac App store). Apple Conﬁ gurator is only available for the Macintosh platform.

If you must use a PC with a Tablet Management product to sync your tablets, please check with the PC manufacturer to

verify that it is designed to handle as least the following number of USB devices:

Tablet Syncing

USB

type B

USB type A

Ergotron Product

PC Capability

Number of USB

Devices*

Tablet Management Station 21

* For setup using iTunes, please see the Tablet Management

Station web page for additional downloadable instructions.

6 of 7

888-33-343-G-01 revB• 07/13

Cleaning and Maintenance

Module and Equipment Electric Safety

There are speci c risks associated with the use of equipment having

power cables. You must be aware of, and avoid these risks when the

Tablet Management Station is located in close proximity to children.

WARNING: Failure to observe the following Electrical Safety

notices can result in  re or death by electric shock.

Electrical cables can be hazardous. Misuse can result in  re or

death by electrical shock.

• Double Pole / Neutral Fusing

• Inspect power cables thoroughly before each use.

• Do not use cables that are damaged.

• Insert the plug completely into the outlet.

• Grasp the plug to remove from the outlet.

• Do not unplug by pulling on the cable.

• Do not use excessive force to make connections.

• Do not plug the cable into an extension cable.

• Do not remove, bend or modify any metal prongs or pins of

cable.

• Do not drive, drag or place objects over the cable.

• Do not walk on the cable.

• Avoid overheating. Uncoil the cable and do not cover it with

any material.

• Do not run cable through doorways, holes in ceilings, walls or

 oors.

Keep the Tablet Management Station away from water.

• Do not use it when wet.

• Do not place the Tablet Management Station in close proxim-

ity to  ammable liquids or gases.

WARNING: Failure to observe the following Tablet Manage-

ment Station Use Safety notices may result in serious personal

injury or equipment damage.

Do not allow children to move the Tablet Management

Station.

• Do not allow anyone to sit, stand, or climb on the unit.

• Do not block the fans and vent openings. To prevent over-

heating, leave at least 127 mm (5-inch) clearance around fans

and vents.

The unit is designed to be used indoors only.

• Do not use the unit for other than what has been noted in

this guide.

• Do not place heavy objects on the unit surface or shelf.

- The maximum weight capacity of each rack is 10 lbs

(4.5 kg).

Moving the Tablet Management Station

Before moving the unit:

1. Disconnect the power cable from the wall.

2. Disconnect the USB cables from the tablets.

3. Make sure the cables are wrapped and secure.

Tablet Management Station Placement

Observe these safety alerts for times when the Tablet Management

Station is stationary:

• Do not place Tablet Management Station on an object or

surface that cannot support its weight: 12.2 lbs (5.5 kg).

• Do not run cables through doorways, holes in ceilings, walls,

or  oors.

• Do not run cables across hallways, classrooms, or other areas

where they will be walked on.

• Do not leave unit unattended in areas where children have

access.

The unit cord acts as the connect/disconnect device switching

power o and on.

Input 100-240 V~, 2.0 A, 50/60 Hz

TABLET MANAGEMENT STATION

35MR

UL 60950

827-068-01

Product was placed

on the market

after 13 August 2005

N13508

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: 1) This device may not cause harmful interference. 2) This device must

accept any interference received, including interference that may cause undesired

operation. CAN ICES-3(A) / NMB-3(A).

7 of 7

888-33-343-G-01 revB• 07/13

Tower dimensions

5.5 W x 8.8 D x 17.0 in H

(140 x 224 x 207 mm)

Rack dimensions

3.5 W x 8.5 D x 2.2 in H

(89.8 x 216 x 55 mm)

Rack weight limit

10 lbs (4.5 kg)

Product weight

12.2 lb (5.5 kg)

LED status indicators (ISI)

Lights indicate power status and syncing activity

17 LED lights

Cooling/ventilation

One 5-volt DC continuous operation fan

Shipping weight

14.9 lb (6.8 kg)

Power System

100-240 V~, 2.0A, 50/60 Hz

Environmental

Temperature range:

Operating 0° to 30°C (32° to 86°F)

Storage -40° to 60°C (-40° to 140°F)

Relative humidity (maximum):

Operating 10%–90% (non condensing)

Storage 5%–95% (non condensing)

Altitude (maximum): 2000 m (6,562 ft)

Compatibility:

Made for

iPhone 5, iPhone 4S, iPhone 3GS, iPod touch (5th generation), iPod touch (4th

generation), iPod touch (3rd generation), iPad mini, iPad with Retina Display (4th

generation), iPad (3rd generation), iPad 2, iPad

Also compatible with most USB devices compliant with the USB 1.2 charging

standard including Samsung Galaxy Tab 2, Amazon Kindle products, Google Nexus

7, Viewsonic, ViewPad 7 and numerous phones by Samsung, HTC, Nokia, Motorola,

Blackberry, Sony and LG.

Speci cations

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device

must accept any interference received, including interference that may cause undesired operation. This Class A digital apparatus complies with Canadian ICES-003. / Cet

appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

For Service Visit www.ergotron.com

Service and Warranty

NOTE: When contacting customer

service, reference the serial number.

www.ergotron.com

MADE IN CN

12-345-678

1234567-1234