Always disconnect the appliance from the power supply before replacing the lamp. The lamp might be in
two different positions, depending on the model.
1. Loosen the screw and remove the diffuser.
2. The lamp has a bayonet mount. It CANNOT BE UNSCREWED: it should be pulled as shown by the
arrow. Replace the light bulb with one with equal power or a power not higher than the maximum limit
indicated by the side of light bulb holder (only available from the Customer Care Centre).
3. Replace the diffuser and wait 5 minutes, before reconnecting the appliance.
REPLACING THE LIGHT BULB
CONTROL PANEL LOCK
The control panel can be locked after selecting the temperature of the refrigerator and freezer
compartment.
Press the keys (13) and (15) at the same time for at least 3 seconds and an acoustic alarm will signal
activation of the function. At this point the entire control panel will remain locked except for the “Acoustic
Alarm” key (11); if any key is pressed, an acoustic signal will sound and the message “CL” will appear on
(4) and (7) display while the key is pressed. To unlock the control panel, proceed as above, pressing the
buttons at the same time, for at least 3 seconds.
FAN AND ANTIBACTERIAL FILTER
The refrigerator compartment is fitted with a fan, light and antibacterial filter module (if applicable). The
fan ensures a better distribution of the temperature inside the refrigerator compartment, with a better
preservation of the food.
The antibacterial filter ensures a high level of hygiene inside the refrigeration compartment through a
continuous purification of the air.
The filter has a life span of 6 months and after this period will need to be replaced. An acoustic alarm and
the flashing of the red warning light (15) will warn that the filter is no longer effective. To disable the
acoustic alarm press the button (11). The red light will however stay on. Filter replacements can be
obtained from the Customer Service Centres. The procedure to replace the filter is explained on the
packing. After replacing the filter press the button (11) for at least 3 second. The system will be reset to
the initial condition and the red warning light (15) will go off. The warning to replace the filter will come
on at six month intervals.
Replacement of the filter is not covered by warranty.
Important:
The fan will only operate when the compressor is on. Do not obstruct the “Suction Zone”.
Note: Ambient temperature, frequency of door opening and position of the appliance can affect the
temperature inside the refrigerator and freezer compartments. These factors should therefore be taken
into account when setting temperatures.
GB
5019 608 01034
Printed in Italy 10/07