1
GB
Before using the dishwasher, read the
installation and maintenance instructions carefully!
5019 496 01116
GSI PL 97
1) Programme data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g. different loads, options, different
sensor settings (only with sensor programmes), different water supply temperatures, as well as water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison
3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697 - November 2001.
1. OVERVIEW
Programme selector
START button
Switches “on” when the dishwasher is operating. Flashes when a
fault occurs. Switches off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected programme
and options are cancelled. Main failure displays (repeated flashing
of the START indicator lamp) can be cancelled by RESETTING.
Detailed instructions are given in chapter 5 “What to do, if...”.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Fault indication and wash time display
With normal operation, the display indicates residual time (h:mm),
while with the “Delayed start” function selected it indicates time
remaining until the start of the programme (hh).
If “F..” appears on the display, see chapter 5 “What to do, if...”.
Delayed start” button
Press the button as required to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time.
Detergent setting upon initial use and when using a different type of detergent
1. Select the third programme in the relative table.
2. Press the START button for approx. 7 sec. to change the display.
3. Using the START button, select the desired detergent:
Display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined action
detergents (in this way, the rinse aid and/or salt indicator is deactivated).
Display shows OFF = Powder detergent (factory setting).
(rinse aid level and salt level indicator activated).
4. Switch the appliance off and then switch it on again. The selected detergent
will be displayed for approx. 3 sec.
Half Load/Multizone button
Load the upper or lower rack only.
Press once = wash upper rack (the indicator light/symbol lights up)
Press twice = wash the lower rack (the indicator light/symbol lights up)
Press 3 times = Off (Half load/Multizone deactivated).
When washing without the upper rack, press the “Half load” (i.e.
“wash lower rack”) button twice; the corresponding indicator/
symbol lights up.
Power Clean
Intensive wash with additional water jets and greater loading
flexibility in the lower rack.
On / Off Button
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Selectable
extra
functions
Loading instructions
large small Litres kWh Minutes
1
Sensor Intensive 60-70°C
Automatic programme
recommended for heavily soiled
crockery with dried-on or burnt food,
for example pans and saucepans.
X X 13-20 1.10-2.00 100-150 ±
1)
2
Sensor Normal 40-55°C
Automatic programme
recommended for routine washes,
with no dried-on or burnt food
(not for EN 50242).
X X 10-13 0.80-1.05 60-120 ±
1)
3
Pre-Rinse cold
Crockery to be washed later.
— — 4.0 0.03 14 ±
1)
4
Glasses 40°C
Light soiling, for example glasses
and cups.
X — 10.0 0.85 100 ±
1)
5
Quickwash 45°C
Lightly soiled crockery, without
dry residuals.
X — 11.0 0.80 30 ±
1)
6
Bio Normal
2)
50°C
Normally soiled crockery,.
Energy-saving programme.
X X 12.0 1.05 165 ±
1)
7
Hygiene +
3)
Normally - heavily soiled crockery,
with additional antibacterial wash.
Programme interruption (e.g. due
to door opening) can compromise
elimination of germs.
X X 13.0 1.50 115 ±
1)