AMX PLK-DMS Dimensional Drawing

Brand: AMX

Model: PLK-DMS

Type: Dimensional Drawing

All information contained herein

reproduced, or used as the basis

for manufacture or sale without

This drawing may not be copied,

has been previously established.

to the extent the information

that is not generally known

property of AMX Corporation.

NOTICE: This drawing is the

shall be confidential except

written permission. PROJECTION

THIRD ANGLE

REL DATE

TOLERANCE ON DECIMAL DIMENSIONS: XX = .010

SURFACE FLATNESS .003 TIR PER LINEAR INCH.

FRACTIONAL DIMENSIONS INCLUDING HOLES: +/- 1/64

DO NOT SCALE THIS DRAWING.

TOLERANCE ON HOLE DIAMETERS:

OVER .500

.250 TO .500

UNDER .250 ú

ALL DIMENSIONS IN INCHES.

ANGLES: +/- 1.0°

= +.008 -.005

= +.006 -.005

XXX = .005

= +/- .005

ENGINEER

PROD ENGR

ENGR SERV

UNLESS OTHERWISE SPECIFIED:

DRAWN

B

SCALE

SIZE DWG. NO.

REL APPR REV APPR

SHEET

REV.

QUALITY

MATL SUP

DATEDESCRIPTIONREV ECN

REVISIONS

APPROVED

PICTORIAL, PLK-DMS

(WHITE AND BLACK MODELS)

95-2405-01

95-2401-01-C

CFULL

1 OF 1

A

--- RELEASED TO PRODUCTION

6/29/00

NAD 6/29/00

MS 6/16/04

RDR 4/5/01

KZ 6/16/04

MB 4/6/01

AK 6/16/04

B 2331A AMX LOGO 8/14/01

C

6124 SHOW CONNECTOR; ADD DIMS

6/16/04 DAS

4.50

[114.3 MM]

3.33

[84.6 MM]

1.54

[39.0 MM]

.29

[7.4 MM]

FROM WALL

1

AMX PLK-DMS Dimensional Drawing

Brand: AMX

Model: PLK-DMS

Type: Dimensional Drawing

Related papers