Installation manual CA-HM-UNI-EVO.001 | Version 1.0
EN - Installation Manual
Mount the locking tabs (bulge up) onto the unit support
Metal cage
Screen bracket
Screen adjuster
Side brackets
Small hardware
Unit bracket
Connector cover
Trim bezel
1-DIN cover
Install the side support with a wrench n°7 (not included)
Install the sliding mecha with the supplied hardware
Once finalised, mount the complete bracket to the silver box
using the supplied hex screws
1 2
43
CA-HM-UNI-EVO.002
INSTALLATION KIT FOR SPH-EVO82DAB
Installation manual SPH-EVO82DAB-UNI | Version 1.0
Slide the metal cage into the vehicle with the opening on top
Close the locking tabs and secure with the necessary screws
Click the plastic tabs onto the metal holder as shown
Whilst sliding the silver box in the car pull the display cable
through using some tape (not included)
Put the DIN cover over the unit
By using the two top screws, mount the screen holder
to the screen
5 6
8
10
7
9
Installation manual CA-HM-UNI-EVO.001 | Version 1.0
Put the screen holder on and fix only the top two screws
After having to determined the correct position
install the bottom cover
install the metal holder - you can adjust height and angle
by using different positions
If the bottom cover collides with the metal bracket,
you need to break off some strips
11 12
1413
Installation manual SPH-EVO82DAB-UNI | Version 1.0
Fix the bottom cover using two screws
Verify the necessary lenght of the neck cover
Slide the cover onto the screen and fix the screw
Slide the screen into the support and secure with two screws
Install the neck cover onto the screen and fix the screws
Put the screw cover over it
15 16
18
20
17
19
Installation manual CA-HM-UNI-EVO.001 | Version 1.0
Final product imageInstall the front cover with the chrome bezel
21 22
/