NOTE: In Sleep Mode the LED will flash GREEN continuously, indicating that the device is working
properly. If the device is not flashing GREEN, there are two possible reasons:
• Flashing Red (slowly) = Indicates a poor connection. Add Conducting Gel and/or reposition the
device on your wrist.
• Flashing Red (rapidly) = Battery Weak. Please replace the battery.
After 30 minutes in Sleep Mode, the device will stop vibrating and enter Anti-Snoring Mode. In
Anti-Snoring Mode, the device remains off until it detects a loud sound of 65dB or more (such
as snoring) three times in a row.
When the device detects snoring (three loud noises in a row), it activates the electrical pulse,
causing you to roll over or shift position without waking up. When you roll over or shift position,
your airway will become clearer, so you do not snore.
NOTE: After 8 hours, the device will turn off automatically to conserve power.
The Power Button has three different settings:
• Press once = Goes to Sleep Mode for 30 minutes, then Anti-Snoring Mode for 8 hours
• Press twice = Goes directly to Anti-Snoring Mode for 8 hours
• Press three times = Off
• Go to bed close to the same time each night.
• Use the device in Sleep Mode for 30 minutes before
going to sleep.
• After use, wipe the black rubber pads with a soft cloth
and store the device in its original box for safe keeping.
• Sleep should improve after 2 to 4 weeks of use.
4. Press the Power button ONCE to enter Sleep Mode. In Sleep Mode,
the device will vibrate at 6,000 RPM to relieve stress. In addition, it
will deliver small electrical impulses to promote circulation and stimulate
the production of melatonin, the body’s own sleep-inducing hormone.
Adjust the intensity to a level that is comfortable. Please be aware that
the electrical impulses are transmitted in a cycle: from weak to strong,
then from strong to weak. Then, the cycle repeats.
INSTRUCTIONS FOR USE
[
CONT.
]
POWER BUTTON
GENERAL USAGE TIPS
- 3 -