PRE-ASSEMBLY PREPARATION:
Assembly requires 2 people-Tools are not included in packaging.
Before assembly,ensure all parts are present and not damaged.
1. Assemble on a flat,hard and even surface
2. Keep canopy swing away from fire or inflammable objects
3. To avoid injury during use, follow these guidelines
a. Do not put arms or legs between seating area and frame of canopy swing.
b. Do not put any objects directly in front or behind the canopy swing.
c. Use canopy swing on a flat, unobstructed surface Excessive swinging will
cause the swing to collapse and may result in injury to persons nearby
4. Maximum load is 550 lbs.
5. Only allow children to use the canopy under adult supervision.
6. Occasionally check sun bed for loose screws, tighten before using.
7. Cover canopy during wet and/or windy weather.
Spare Parts List , Hardware List ,
Required Tools and Structural Diagram
TOOLS REQUIRED:
STEP-BY-STEP ASSEMBLY :
Step 1. Join part 1 and part 2 by part E first, then join part 1 , part 3 and
part 4 by part B .
Step 2. Join part 3, part 4 and part 5 by part E first, then join part 6 and
part 7 by part F , then join part 4 and part 6 by part C .
Step 3. Join part 8 and part 9 by part D.
Step 4. Hang the seat on the steel frame by part G.
Step 5. Insert part 11 into part 12 , then insert part 10 into part 11 , then
put the four corners of part 11 into the corners of part 12.
Step 6. Join part 1 and part 10 by part F first, then join part 1 and part 10
by part H , so the incline of canopy can be adjusted.
Step 7 (optional). Part 14 can be used to fix the feet to grassland. Put part 14 over
each leg and anchor into ground.
/
