AEG X66453BVO Owner's manual

X66453MVO

X69453MVO

X66453BVO

X69453BVO

Libretto Istruzioni

User Manual

Mode D'emploi

Bedienungsanleitung

Gebruiksaanwijzing

Manual De Instrucciones

Manual De Instruções

Kullanim Kilavuzu

IT

EN

FR

DE

NL

ES

PT

TR

CAPPA

COOKER HOOD

HOTTE DE CUISINE

DUNSTABZUGSHAUBE

AFZUIGKAP

CAMPANA

EXAUSTOR

OCAK DAVLUMBAZ

3

10

17

24

31

38

45

52

Page is loading ...

FOR PERFECT RESULTS

Thank you for choosing this AEG product. We have created

it to give you impeccable performance for many years, with

innovative technologies that help make life simpler – fea-

tures you might not find on ordinary appliances. Please

spend a few minutes reading to get the very best from it.

ACCESSORIES AND CONSUMABLES

In the AEG webshop, you’ll find everything you need to keep

all your AEG appliances looking spotless and working per-

fectly. Along with a wide range of accessories designed and

built to the high quality standards you would expect, from

specialist cookware to cutlery baskets, from bottle holders to

delicate laundry bags…

Visit the webshop at:

www.aeg-electrolux.com/shop

EN - RECOMMENDATIONS AND SUGGESTIONS/CHARACTERISTICS

11

EN - RECOMMENDATIONS AND SUGGESTIONS - The Instructions for Use apply to several versions of this appliance. Accordingly, you may ﬁ nd descrip-

tions of individual features that do not apply to your speciﬁ c appliance. The manufacturer will not be held liable for any damages resulting from incorrect or improper

installation. The minimum safety distance between the cooker top and the extractor hood is 650 mm. Check that the mains voltage corresponds to that indicated on

the rating plate ﬁ xed to the inside of the hood. For Class I appliances, check that the domestic power supply guarantees adequate earthing. Connect the extractor to

the exhaust ﬂ ue through a pipe of minimum diameter 120 mm. The route of the ﬂ ue must be as short as possible. Do not connect the extractor hood to exhaust ducts

carrying combustion fumes (boilers, ﬁ replaces, etc.). If the extractor is used in conjunction with non electrical appliances (e.g. gas burning appliances), a sufﬁ cient

degree of aeration must be guaranteed in the room in order to prevent the backﬂ ow of exhaust gas. The kitchen must have an opening communicating directly with

the open air in order to guarantee the entry of clean air. The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use

the hood for purposes other than for which it has been designed. Never leave high naked ﬂ ames under the hood when it is in operation. Adjust the ﬂ ame intensity

to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil

can burst into ﬂ ames. Do not ﬂ ambè under the range hood; risk of ﬁ re This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a

person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Switch off or unplug the appliance from the

mains supply before carrying out any maintenance work.Clean and/or replace the Filters after the speciﬁ ed time period (Fire hazard), Grease ﬁ lters Z The ﬁ lters must

be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. - Activated charcoal ﬁ lter W These

ﬁ lters are not washable and cannot be regenerated, and must be replaced approximately every 4 months of operation, or more frequently with heavy usage. Clean the

hood using a damp cloth and a neutral liquid detergent. The symbol

on the product or on its packaging indicates that this product may not be treated as household

waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed

of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste

handling of this product. For more detailed information about recycling of this product, please contact your local city ofﬁ ce, your household waste disposal service or

the shop where you purchased the product.

Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm.

Warning: Before installing the Hood, remove the protective ﬁ lms (white and transparent).

CHARACTERISTICS

Dimensions

EN - RECOMMENDATIONS AND SUGGESTIONS/CHARACTERISTICS

12

Components

Ref. Q.ty Product Components

1 1 Hood Body, complete with: Controls,

Light, Blower, Filters

8 1 Directional Air Outlet grille

9 1 Reducer Flange ø 150-120 mm

10 1 Dumper

16 1 Filter cover

Ref. Q.ty Installation Components

11 2 Wall Plugs

11a 2 Wall Plugs SB 12/10

12a 2 Screws 4,2 x 44,4

12c 4 Screws 2,9 x 6,5

12d 2 Screws 2,9 x 9,5

Q.ty Documentation

1 Instruction Manual

1

11

12a

9

11a

16

12c

12d

8

10

EN - INSTALLATION

13

INSTALLATION

Wall drilling and bracket fixing

As a first step, proceed with the following drawings:

• a vertical line up to the ceiling or up to the upper limit, at the centre of the area in which the

hood is to be fitted;

• a horizontal line at a minimum 1004 mm above the cooker top.

• Mark a point (1) on the horizontal line, 247 mm to the right of the vertical reference line.

• Repeat this operation on the other side, checking that the two marks are levelled.

• Mark a reference point (2) as indicated at 210 mm from the vertical reference line and 482

mm above the cooker top.

• Repeat this operation on the other side, checking that the two marks are levelled.

• Drill at the marked points (1), using a ø 12 mm drill bit.

• Drill at the marked points (2) using a ø 8 mm drill bit.

• Insert the bracket plugs 11a into the holes (1) and tighten the screws.

• Insert plug 11 into holes (2).

To install a decorative chimney ( optional )

• Place bracket 7.2.1 on the wall, about 1-2 mm from the ceiling or from the upper limit,

aligning the centre (notch) with the vertical reference line.

• Mark the wall at the centres of the bracket holes.

• Place the bracket 7.2.1 on the wall at X mm below the first bracket (X = height of the upper

chimney section), aligning the centre (notch) with the vertical line.

• Mark the wall at the centres of the bracket holes.

• Drill ø 8 mm holes at all the marked centre points.

• Insert the wall plugs 11 in the holes.

• Fix the brackets using the 12a screws (4,2 x 44,4) supplied with the hood.

11a

1

22

210

11

12a

247 247

1004

482

400

210

X

1÷2

7.2.1

EN - INSTALLATION

14

FITTING THE HOOD BODY

• Open the top suction panel and fasten it to the

hood body on the left using the pin, so that it

does not close again.

• Unlock the lower suction panel by removing the

fixing pin on the left, and open it.

• Remove the Metal grease filters using the handles

provided.

• Adjust the two screws Vr, in the brackets 11a, so

that they are at the start of their travel.

• Hook the hood body to the two brackets 11a.

• From the inside of the hood body, turn screws Vr

to level the hood body itself.

• Fasten the safety screws 11.

• Close the suction panels.

CONNECTIONS

DUCTED VERSION AIR EXHAUST SYSTEM

When installing the ducted version, connect the hood

to the chimney using either a flexible or rigid pipe

ø 150 or 120mm, the choice of which is left to the

installer.

To install a ø 150 pipe

• To install the dumper 10

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

To install a ø 120 pipe

• To install a ø 120 mm air exhaust connection,

insert the reducer flange 9 on the dumper 10.

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

• Remove any activated charcoal filters.

RECIRCULATION VERSION AIR OUTLET

.

• Screw the filter cover onto the air outlet, using

four screws 12c (2.9 x 12.5).

• Fix the directional grille 8 on the recirculation air

outlet using the 2 screws 12d (2,9 x 9,5) pro-

vided.

ø 120

ø 150

10

9

Vr

11

11a

16

12c

12d

8

EN - INSTALLATION

15

ELECTRICAL CONNECTION

• Connect the hood to the mains through a

two-pole switch having a contact gap of at

least 3 mm.

• Remove the grease filters (see paragraph

Maintenance) being sure that the connector

of the feeding cable is correctly inserted in

the socket placed on the side of the fan.









EN - USE

16

A

B

C D

E

F

G H

USE

Button Function Led

A

Turns the Lighting System on and off.

If pressed and held for 5 seconds with the hood turned off and

no alarm, do:

Enables the Activated Charcoal Filter Alarm.

Disables the Activated Charcoal Filter Alarm.

On or Off

2 Flashes Led buttom H

1 Flash Led buttom H

B

Turns the Motor on and off.

Enables Keyboard Lock mode if pressed and held for 5 seconds.

It is disabled by pressing the button for 5 seconds.

On or Off

All the Leds flash twice and during Keyboard

Lock the Leds light up in sequence.

All the Leds flash once.

C

Activates speed one. On.

D

Activates speed two. On.

E

Activates speed three. On.

F

Activates intensive speed from any other speed, including motor

off. This speed is timed to run for 5 minutes, after which the

system will return to the speed that was previously set. Suitable

to deal with se-vere cooking fumes.

It is deactivated by pressing the button or turning the motor off.

On.

G

Activates delayed automatic shutdown of the motor and the

lighting system after 15 minuts.

Suitable to complete the elimination of residual odours, it is

deactivated by press-ing the button of turning the motor off.

If pressed and held for 5 seconds with the hood and lightturned

off and no alarm, do:

Enables the Remote control.

Disables the Remote control.

On.

2 Flashes Led buttom C + B

1 Flash Led buttom C + B

H

Performs a Reset of the Filter saturation alarm when the button

is pressed for ap-proximately 2 seconds with the hood turned

off.

After 100 hours operation the Led lights up

continuously to indicate saturation of the

Metal Grease Filters.

After 200 hours operation the Led flashes to

indicate saturation of the Activated Charcoal

Filters.

Page is loading ...

NL - ADVIEZEN EN SUGGESTIES/EIGENSCHAPPEN

33

Onderdelen

Ref. Productonderdelen

1 1 Wasemkap compleet met:

Bedieningen, Licht, Ventilatorgroep,

Filters

8 1 Richtingrooster luchtuitlaat

9 1 Reductieflens ø 150-120 mm

10 1 Toom met Klep ø 150

16 1 Filterdeksel

Ref. Installatieonderdelen

11 2 Pluggen

11a 2 Pluggen SB 12/10

12a 2 Schroeven 4,2 x 44,4

12c 4 Schroeven 2,9 x 9,5

12d 2 Schroeven 2,9 x 9,5

Documentatie

1 Gebruiksaanwijzing

1

11

12a

9

11a

16

12c

12d

8

10

Page is loading ...

PARA OBTENER RESULTADOS PERFECTOS

Gracias por escoger este producto AEG. Este artículo ha

sido creado para ofrecer un rendimiento impecable durante

muchos años, con innovadoras tecnologías que facilitarán

su vida y prestaciones que probablemente no encuentre

en electrodomésticos corrientes. Por favor, dedique algunos

minutos a la lectura para disfrutar de todas sus ventajas.

ACCESORIOS Y CONSUMIBLES

En la página web de AEG, encontrará todo lo necesario para

la perfecta limpieza y funcionamiento de todos sus electro-

domésticos AEG. Junto con una amplia gama de accesorios

diseñados y fabricados conforme a los elevados estándares

de calidad característicos de la marca, desde utensilios de

cocina especializados a cestos de cubiertos, desde portabote-

llas a bolsas para el lavado de prendas delicadas...

Visit the webshop at:

www.aeg-electrolux.com/shop

Page is loading ...

PARA RESULTADOS PERFEITOS

Obrigado por escolher este produto AEG. Criámo-lo para

lhe oferecer um desempenho impecável durante vários

anos, com tecnologias inovadoras que tornam a sua vida

mais fácil – funcionalidades que poderá não encontrar

em aparelhos convencionais. Continue a ler durante al-

guns minutos para tirar o máximo partido do produto.

ACESSÓRIOS E CONSUMÍVEIS

Na loja web AEG, encontrará tudo aquilo de que neces-

sita para manter os seus aparelhos AEG imaculados e a

funcionarem na perfeição. A par de uma vasta gama de

acessórios projectados e concebidos de acordo com os pa-

drões de elevada qualidade que esperaria, de utensílios de

cozinha especializados a cestos de talheres, de suportes

para garrafas a delicados sacos para roupa...

Visit the webshop at:

www.aeg-electrolux.com/shop

Page is loading ...

www.aeg-electrolux.com/shop

436005002_08 - 110404

AEG X66453BVO Owner's manual

This manual is also suitable for

AEG X66453BVO Owner's manual

in other languages

Related papers

Other documents