Customer Key Programming
Programming Key Fobs or RKE transmitters
may be performed at an authorized dealer.
General Information
The Sentry Key® operates on a carrier fre-
quency of 433.92 MHz. The Sentry Key® Im-
mobilizer system will be used in the following
European countries, which apply Directive
1999/5/EC: Austria, Belgium, Czech Republic,
Denmark, Finland, France, Germany, Greece,
Hungary, Ireland, Italy, Luxembourg, Nether-
lands, Norway, Poland, Portugal, Romania,
Russian Federation, Slovenia, Spain, Sweden,
Switzerland, Slovenia, Croatia, and United
Kingdom.
Operation is subject to the following conditions:
• This device may not cause harmful interfer-
ence.
• This device must accept any interference
that may be received, including interference
that may cause undesired operation.
VEHICLE SECURITY ALARM —
IF EQUIPPED
This Vehicle Security Alarm monitors the ve-
hicle doors, hood, liftgate, and ignition for unau-
thorized operation. While the Vehicle Security
Alarm is armed, interior switches for door locks
and liftgate release are disabled. If something
triggers the Vehicle Security Alarm the horn will
sound for 29 seconds and turn off all of the
visual signals after an additional 31 seconds. If
the triggering device isnot deactivated,the horn
will sound again after a five second delay for
another 29 seconds. If the trigger remains pres-
ent, this cycle will repeat for up to five minutes.
To Arm The System
Follow these steps to arm the Vehicle Security
Alarm:
1. Remove the key from the ignition system
(refer to "Starting Procedures" in "Starting And
Operating" for further information).
• For vehicles equipped with Keyless Enter-N-
Go™, make sure the vehicle ignition system
is "OFF".
• For vehicles not equipped with Keyless
Enter-N-Go™, make sure the vehicle ignition
system is "OFF" and the key is physically
removed from the ignition.
2. Perform one of the following methods to lock
the vehicle:
• Press LOCK on the interior power door lock
switch with the driver and/or passenger door
open.
• Press the LOCK button on the exterior Pas-
sive Entry Door Handle with a valid Key Fob
available in the same exterior zone (refer to
"Keyless Enter-N-Go™" in "Things To Know
Before Starting Your Vehicle" for further
information).
• Press the LOCK button on the Remote Key-
less Entry (RKE) transmitter.
3. If any doors are open, close them.
To Disarm The System
The Vehicle Security Alarm can be disarmed
using any of the following methods:
• Press the UNLOCK button on the Remote
Keyless Entry (RKE) transmitter.
16
PAGE POSITION: 18 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1461427-en-2014_CHEROKEE_EE+14KL-126-ENG-AA/DIV_Owners_Manual_v2