Peavey SP-15825 User manual

Category
Equipment cleansing kit
Type
User manual

Peavey SP-15825 is a 15” loudspeaker designed to high-level professional requirements such as sound reinforcement, low-frequency musical instrument applications, and public address. Due to the impregnation with Kevlar®, this device maintains an extremely rigid platform that can provide enhanced linearity at high drive levels. Consequently, it delivers high fidelity through lower distortion. The Scorpion Plus 15" Kevlar® impregnated cone loudspeaker is another example of versatility and reliability sound in all Peavey products.

Peavey SP-15825 is a 15” loudspeaker designed to high-level professional requirements such as sound reinforcement, low-frequency musical instrument applications, and public address. Due to the impregnation with Kevlar®, this device maintains an extremely rigid platform that can provide enhanced linearity at high drive levels. Consequently, it delivers high fidelity through lower distortion. The Scorpion Plus 15" Kevlar® impregnated cone loudspeaker is another example of versatility and reliability sound in all Peavey products.

PEAVEY ELECTRONICS
15” Scorpion
®
Replacement
Basket
The Peavey Scorpion
®
Plus
15”
loudspeaker was designed to high
level professional requirements,
which is sound reinforcement,
public address, and low frequency
musical instrument applications.
Impregnated with Kevlar
®
to
maintain an extremely rigid
platform that can provide enhanced
linearity at high drive levels. At any
drive level, Kevlar gives the added
benet of greater mechanical
damping, resulting in higher delity
through lower distortion.
The Scorpion Plus unique
suspension design further
contributes to the high reliability in
very low distortion by allowing very
long excursions with associated
low distortion. The large spoke
die cast, aluminum frame, and
eld replaceable cone assembly
are features usually found in ultra
premium transducers such as the
Peavey Black Widow
®
Series.
The Scorpion Plus 15” Kevlar
®
impregnated cone loudspeaker is
another example of the versatility
and reliability sound in all Peavey
products.
Kevlar
®
is a registered trademark of DuPont Company
SPECIFICATIONS
Diameter – 15”
Nominal Impedance – 8 ohms / 4 ohms
Power Handling Capacity –
Continuous 200 watts
Program* 400 watts
Sensitivity – 101 dB (8 ohms) / 100 dB (4 ohms)
Voice Coil Diameter – 2.5 inches
Flux Density – 13000 Gauss
Depth – 5 7/8 inches
Net Weight – 12 ¾ lbs.
THIELE/SMALL PARAMETERS
Znom 8 Ohms 4 Ohms
Fs 50.2 Hz 49.4 Hz
RE 5.54Ω 3.35Ω
QTS 0.326 0.415
VAS 132.4L 138.9L
VD 22.1 in3 (362 ml) 22.1 in3 (362 ml)
Efciency (half space) 4.70% 3.62%
SD (diaphragm area) 0.0731M
2
0.0731M
2
*This specication requires a minimum of 2 dB of amplier headroom.
Scorpion
®
Basket
Assembly
Replacement
Replaceable baskets
eliminate the need for
re-coning speakers
and the frustration and
delays associated with
the re-coning process. It
only takes a few minutes
to replace a basket and
you are back in business.
It just can’t get any
easier than the four steps
outlined here.
1 Remove three screws on back of magnet structure.
2 Lift the magnet structure off the basket frame.
3 Clean the voice coil “gap”.
4 Align screw holes, lower structure into place on new
basket frame, insert screws and tighten.
1
2
3
4
Baskets are replaced in four easy steps:
ONE YEAR LIMITED WARRANTY
NOTE: For details, refer to the warranty statement. Copies of this statement may be obtained online at www.peavey.com.
Features and specications subject to change without notice.
Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305
(601) 483-5365 • FAX (601) 486-1278 • www.peavey.com
©2011 Printed in the U.S.A. 1/11 80300072
Logo referenced in Directive 2002/96/EC Annex IV
(OJ(L)37/38,13.02.03 and defined in EN 50419: 2005
The bar is the symbol for marking of new waste and
is applied only to equipment manufactured after
13 August 2005
  • Page 1 1
  • Page 2 2

Peavey SP-15825 User manual

Category
Equipment cleansing kit
Type
User manual

Peavey SP-15825 is a 15” loudspeaker designed to high-level professional requirements such as sound reinforcement, low-frequency musical instrument applications, and public address. Due to the impregnation with Kevlar®, this device maintains an extremely rigid platform that can provide enhanced linearity at high drive levels. Consequently, it delivers high fidelity through lower distortion. The Scorpion Plus 15" Kevlar® impregnated cone loudspeaker is another example of versatility and reliability sound in all Peavey products.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI