2. Pelco
  3. CV-D2000

Pelco CV-D2000 User manual

  • Hello! I am an AI chatbot trained to assist you with the Pelco CV-D2000 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
C1006RN (1/09) Page 1 of 2
IPIX IP Cameras Supported on Digital Sentry
Integral Digital Sentry
®
digital video management systems (DVMS) support certain
IPIX
®
IP camera models. The camera models listed in this document can be used with
Digital Sentry IP camera driver 6.8.0.126 and later. Refer to each camera’s table for
information about the hardware and software features validated for use on a Digital
Sentry system. Any general limitations or special instructions are listed at the beginning
of the document, and any model-specific information is listed after each table. For
information about the general usage of each camera, refer to the camera manufacturer’s
documentation.
To obtain the latest IP camera driver or documentation for use with Digital Sentry, refer
to the Pelco Web site at
www.pelco.com
.
IPIX CommandView
™
Dome CV-D2000
IPIX CommandView Dome CV-D3000
Firmware N/A
Supported Resolutions 1600 x 1200
Frames per Second (FPS) 1 to 20
Number of Quality Settings 10
Supported Codec MJPEG
Supported Motion Detection In-Camera
Pan/Tilt/Zoom (PTZ) Yes (solid state)
Firmware N/A
Supported Resolutions 2048 x 1536
FPS 1 to 12
Number of Quality Settings 10
Supported Codec MJPEG
Supported Motion Detection In-Camera
PTZ Yes (solid state)
Release Notes
Page 2 of 2 C1006RN (1/09)
IPIX InSight
™
IS-N2000
Contact Information
Pelco Worldwide Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada: Tel: (800) 289-9100, Fax: (800) 289-9150
International: Tel: +1(559) 292-1981, Fax: +1(559) 348-1120
www.pelco.com
Document Revision History
Firmware N/A
Supported Resolutions 1600 x 1200
FPS 1 to 17
Number of Quality Settings 10
Supported Codec MJPEG
Supported Motion Detection In-Camera
PTZ Not available
Document # Date Comments
C1006RN 1/09 Original version.
Pelco, the Pelco logo, and Digital Sentry are registered trademarks of Pelco, Inc.
IPIX is a registered trademark of IPIX Corporation.
CommandView and InSight are trademarks of IPIX Corporation.
© Copyright 2009, Pelco, Inc. All rights reserved.
/