Genelec 8000-422B/W Adjustable wall mount Operating instructions
- Category
- Flat panel wall mounts
- Type
- Operating instructions
8000-422B/W WALL MOUNT for GENELEC 6010A, 8020B, 8030A black/white
Instruction Manual
1. Equipment 2. Separate speaker
2. holder from wall plate
4. Wall mount fastening
2.b
Remove
speaker holder
from wall plate
4.a.1 Two-hole-pattern 4.a.2 Three-hole-pattern
2.a
Loosen
lower bolted
assembly
4.a
Adjust decorative plate according to the drilled two-or-three-hole-pattern
4.b
Bolt down the wall plate along with the decorative plate
onto the wall
Use two or three screws depending on the prepared hole pattern
speaker holder
with wall plate
decorative
plate
3.b.1 Two-hole-pattern 3.b.2 Three-hole-pattern
3.c Anchor holes drilling
3.c for two or three hole
3.c pattern: - dia. 8 mm
3.d Blow out holes and
3.d place anchors
3.a Determine wall fastening
3.a.1 Provided screw/dowel set is suitable for:
concrete, full brick, perforated brick & drywall
3.a.2 For other walls like wood, adobe etc. use adequate anchors
3.b Adjust wall plate vertically and mark drilling holes (two options):
3. Wall mount preparation
Safety Instructions
- Choose a position and mounting method compliant with local
- building codes and regulations
- For use only by trained installers
- For use only at proper walls with adequate anchors
- Not suitable are fragile walls.
- Beware of power supply lines and water conduits.
- In case ask an expert.
- Inspect bolted assemblies periodly
- For indoor use only
8000-422B/W WALL MOUNT for GENELEC 6010A, 8020B, 8030A black/white
Instruction Manual
5. Speaker installation
6.a.1
tilting marks
(no latching)
6.b.1
pivoting mark
centric adjustment 90°
(no latching)
6.b - DIRECTION
Pivoting attachment
around vertical axis
Weight: 0,5 kg
6.a - TILT ANGLE
Continuously adjustable tilting angles:
-up to 30-60° -down to 20-30°,
Fix both lateral allen screws (AF5 mm)
6. Settings (speaker-based) 7. Dimensions
7. (in mm)
5.a
Bolt
speaker plate to
GENELEC speaker
5.b Replace the bolt of the speaker plate
5.b (with mounted GENELEC)
5.b into wall bracket
5.c Fix wall plate and
5.c speaker bracket by tightening
5.c lower bolted assembly
GENELEC Oy
Olvitie 5, Fin-74100 Iisalmi, www.genelec.com
24160-000-56/66 Rev.03 03-80-273-00 9/12
-
1
-
2
Genelec 8000-422B/W Adjustable wall mount Operating instructions
- Category
- Flat panel wall mounts
- Type
- Operating instructions
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Genelec 6010A Studio Monitor Installation guide
-
-
-
-
-
-
-
-
-
